0
Add your answer:
Earn +20 pts
How do you grease the front bearings on a 1991 S-10?
If you are talking about the hub bearings , you can't grease them , they are a sealed unit .
How do you change wheel bearings on a 1991 Toyota pickup 2WD?
A wrench
Does the 1991 Buick century have sealed wheel bearings?
Yes, on Buick Century 1991 you need to replace the whole hub, it is much easier than replacing individual bearings.
Do the front wheel bearings on a 1991 Honda Accord have to be pressed out?
yes they do. I have a 1991 Honda civic and I needed to press them in and I believe they have the same front end.
Where is the fuse box on a 1991 mercury grand marquis?
the fuse box on a 1991 ford grand marquis is located right under the steering wheel
Why does your 1991 Chevy Cavalier make a buzzing sound from the front left when driving straight or turning left but not when turning right?
This buzzing indicates that the wheel bearings need to be replaced on your front left wheel. This can be fixed by changing the bearings themselves or replacing the entire wheel hub.
How many front wheel bearings need to be replaced on a 1991 Ford Ranger 4x4.Is there 2 or a total of 4 bearings.?
there are a total of 4 wheel bearings on the front both sides have an inner and outer bearing. the outer bearing is visable when you remove hub the inner bearing is visable when you remove rotor
How do you replace rear wheel bearings on a 1991 Dynasty And how tight do you torque the wheel bearing nut?
you have to press it out and press the new one in just make sure you tighting it real good
How do you change the wheel bearings for a 1991 Honda civic sedan?
Remove the tire and wheel. Remove the axle end cap. Remove the wheel bearing nut. Remove the wheel bearing seal. Remove the wheel bearing. Reverse the process to install the new wheel bearing.
How do you replace the wheel bearings on a 1991 Chevy Lumina van?
This is a very hard job without the proper equipment. Not recommended for the novice. It will also depend which bearings you are asking about, front or back. Both equally hard to do.
Who knows 1991 maxima vg30e autotrans --dry--- grinding like hum vibration front drivers wheel area wheel bearing TRANS AXEL TIGHT NOT TRANNY ONLY WHEN DRIVING NOT BRAKES NO CV CLICK TIRE IS BALANCED?
ANSWERING MY OWN QUESTION....YES ITS THE WHEEL BEARINGS.... You have ruled out all the causes for yourself. Why would you be asking the question? Yes, it seems that it would be the Wheel Bearings
How do you change the front wheel bearings on a 1991 Olds 98?
YOU HAVE TO TAKE THE HUB ASSEMBLY OFF AND HAVE A SHOP PRESS THE BEARING,OR REPLACE THE HUB ASSEMBLY FROM A SALVAGE YARD.
