0
What else can I help you with?
How do you stop the battieriess from reversing polarities when the batteries are in series?
In a negative ground system, hook the vehicle ground (frame) to the negative of the first battery, positive of that battery to negative of second battery and the positive of the second battery back to vehicle positive. ( starter or starter solenoid) If you are hooking 2 12 volt batteries in series you will have 24 volts.
Can you hook a negative ground unit to a positive ground system?
Make sure thatit is isolated from other electrical components
Can you hook up a cigarette lighter to a lawn mower?
yes. hook it to the batteries on the positive and negative with a splice
How do you hook up 8 volt batteries in series?
How to hook up 6 8v batteries in searise <><><> Batteries connected in series have the negative (-) of one connected to the positive (+) of the next, until all 6 batteries are connected.
How do you connect two batteries to work as one?
Type your answer here... To use two batteries as a single power source, you have to connect the positive to the negative and the remaining negative to ground. The remaining positive goes to the red positive cable. The batteries are now in a series circuit. If you use two 6 volt batteries the total voltage is 12 volts. If you use 2 12 volt batteries the total voltage is 24 volts. If you hook the batteries both negative to negative and positive to positive you have made a parallel circuit. Batteries in a parallel circuit cancel each other out. Two 6 volt batteries in parallel have a total voltage of 0 volts. klb
How do you hook up a 6 volt positive ground ignition coil on a 1949 ford tractor?
To hook up a 6-volt positive ground ignition coil on a 1949 Ford tractor, first ensure the tractor's battery is disconnected. Connect the positive terminal of the coil to the ignition switch, and the negative terminal to the distributor. Make sure the battery's positive terminal is connected to the chassis ground, as the system operates on positive ground. Finally, reconnect the battery and check for proper spark when cranking the engine.
How do you hook the battery charger on a positive ground system?
Connect the positive clip of the charger onto the positive post of the dead battery. If the battery is located inside of a vehicle, connect the positive charger clip to a grounded surface--like an engine block--on the vehicle.
How do you hook 2 12 volt batteries together together to get 24 volts in a positive ground tractor?
Connect the positive terminal on one battery to the negative terminal on the other with heavy wire and battery clamps. Connect the remaining positive terminal to the metal chassis of the tractor, and run the remaining negative wire to the items to be powered, with any luck at all, through a fusebox.
Is there a positive terminal under the hood of a 2004 Jaguar XJ8 where you can hook up a positive booster cable?
There are two batteries on a modern XJ8. One is in the trunk area.
How do you jump start a 2000 intrepid?
there is a small box where the battery would be that you hook the positive to and you can just hook the negative to anything that would ground it
Proper hook up of jumper cables to a semi truck?
Depends on what year it's from. On an older truck, hook the positive to a positive battery post, hook the ground to a bolt which goes through the chassis. On a newer truck, which is apt to having chassis-mounted electronics, put the ground to the negative battery terminal.
How do you hook up battery on a 1994 mighty max does the plus go to the block and does the - go to the starter.?
No! Unless this a positive ground system (highly unlikely) then the '-' always goes to ground (e.i. engine block, frame, a metal thing in general) and the positive goes to the starter or starter solenoid.
