answersLogoWhite

0


Best Answer

IF ITS AFTERMARKET:.... REMOVE THE OLD CD-PLAYER/RADIO....GO TO CIRCUIT CITY OR ANY AUDIO STORE AND ASK FOR A HARNESS TO FIT YOUR CD/RADIO PLAYER TO YOUR SPECIFIC VEHICLE.... THEN PLUG AND PLAY THAT SIMPLE...

User Avatar

Wiki User

โˆ™ 2005-12-28 22:55:48
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How do you hook up a CD-radio-tuner in a 1997 Mercury Mystique?
Write your answer...
Submit
Related questions

Why is the Check engine light on a 1998 mercury mystique?

HAVE AN AUTO STORE OR SHOP HOOK UP THE OBD2 SCANNER TO SEE WHAT CODES ARE


1998 Mercury Mystique ECC Fuse keeps blowing?

Unplug the ECC fuse. If the fuse does not blow, then hook up the ECC. If the fuse blows then the ECC will need to be replaced.


Where do you hook an OBD code reader on a 1997 Mercury Cougar?

passenger side panel, above left knee


Where is the radio antenna wire for CD player hook up located in 1997 mercury mountaineer?

Its in the dash with te other harnesses...(orange.....i think)


How do you turn the check engine light off in a 1995 Mercury Mystique?

You will have to fix the problem with the car, most places like auto zone can hook up a code scanner to the for free and tell you the reason the check engine light is on, once you get an answer, then you can fix the problem and the light should disappear.


Where is the diagnotic hook up on a 1995 Mercury Villager?

Lower right on the fuse box.


Why does the idle fluctuate between high and low after warming up on your 99 mercury mystique after changing plugs wires pcv valve and air filter?

Might be a Throttle Position Sensor. Your best bet would be to hook it up to a computer and check for any codes. OR... you can hook up a multi meter to the tps plug and check the voltage sweep. 5v. max at wide open throttle! Set the meter to check resistance or ohms.


Were do you hook a chain to remove mercury 150 outboard boat motor?

Mercury Marine uses a lifting eye that threads into the flywheel hub for mounting, and removing, the engine.


How do you remove wiper blades on a 1997 Subaru legacy?

The 1997 Subaru Legacy has the most common hook-end wiper arms. There will be a little tab or button where the wiper blade is inserted into the hook on the wiper arm. Press and pull wiper blade out of hook. Sometimes you need to rotate and flex the blade a little bit to make enough clearance. See hook arm videos below.


How do you remove the wiper assembly on a 1997 on a 1997 Pontiac grand am?

The 1997 Pontiac Grand Am has the most common hook-end wiper arms. See the Sources and Related Links section below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.


Where do you hook the obd reader on a 1997 Chevy blazer?

The 1997 Chevrolet Blazer OBD 2 port is on lower edge of dash; right of parking brake


What are the release dates for The Angry Beavers - 1997 Specs Appeal Things That Go Hook in the Night 4-9?

The Angry Beavers - 1997 Specs Appeal Things That Go Hook in the Night 4-9 was released on: USA: 6 January 2001


How do you hook up the spark plug wires to the distrbutor cap on a 1987 Mercury Cougar?

You can find the correct firing order for your 1987 mercury cougar at www.coolcats.com, it is a website dedicated to the cougar and thunderbird.


Where do you hook a chain on the rear of a 1997 Chev Lumina to tow it?

Anywhere BUT the control arm. I did that and it ruined my car.


How do you jump start a Dodge Intrepid?

1993-1997 you hook the cables to the battery. 1998-2004 you hook the cable to the jump start posts under the hood, passenger side.


How do you take windshield wipers off 2001 grand marquis mercury?

The 2001 Mercury Grand Marquis has the most common hook-end wiper arms. See sources and related links below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.


How do you change the rear wiper blade on your 2001 Mercury Sable?

The 2001 Mercury Sable has the most common hook-end wiper arms on front and rear. See the Sources and Related Links section below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.


How do you remove wiper blades 1995 grand marquis mercury?

The 1995 Mercury Grand Marquis has the most common hook-end wiper arms. See Sources and Related Links below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.


How do you change wiper blades on 2006 Mercury Grand Marquis?

The 2006 Mercury Grand Marquis has the most common hook-end wiper arms. See Sources and Related Links below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.


How do you know my 02 sensor is bad on Audi a4 1997?

Need to hook upto a scanner. Check for codes.


How do you remove the windshield wiper blade on and 1997 Jaguar XJ6?

The 1997 Jaguar XJ6 has the most common hook-end wiper arms. See sources and related links below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.


How do you remove the windshield wiper blade on a 1997 Thunderbird?

The 1997 Ford Thunderbird has the most common hook-end wiper arms. See sources and related links below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.


How do you change the wiper blades on a 1997 caravan?

The 1997 Dodge Caravan has the most common hook-end wiper arms. See sources and related links below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.


How do you change the wiper blades from a 99 mercury sable?

This vehicle has hook wiper arms. Find little tab on wiper blade where its inserted into the hook. Press tab and pull wiper out of hook. You may need to rotate blade to make clearance. Sometimes you have to flex the blade a little to in order to make enough room. See video for hook arms on the related link below.


Is a Chrysler radio compatible with Mercury villager 1998?

A Chrysler radio will not hook up to the wiring in a Villager, nor will it fit the mounting bracket.