answersLogoWhite

0


Best Answer

If you got an external tach gauge at an auto store like i did, it should have four wires to be hooked up: a red, black, white and green one. Your suppose to hook the red up to the proper voltage fuse and then ground the black one on the frame or body of the car but im too lazy so i just ran them straight to the battery; not the most professional way but it hasn't drained my battery yet and it works just fine. the white wire is for the light(if your tach has one); i hooked it of to the foglight switch so it lights up whenever i turn the lights on(even if the foglights are turned of if you hook the wire into the left side). the green wire is the tach gauge wire. the ignition coil should have a "tach test" outlet which is basically for mechanics but i put the wire on it and put the cover back over it to hold it in place and everything worked as it should. ONCE AGAIN, this is not the professional method to do it, i didnt use any proper fuses or splices so if your looking for a pristine setup find another method or get it installed the next time your in a shop, but this works just as well.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you hook up a tach to a 1987 Jeep wagoneer?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What wire do you hook to on the distributer or coil to hook up a tach?

You would hook to the negative side of the coil. Some HEI distributor caps are marked "tach".


How do you hook up a sunpro tach to a 98 Toyota tacoma 2.4l 5 speed?

how do you hook up a sunpro super tach 2


If you are trying to hook up a tach to your '90 Bonneville which wire should you hook it up to to get an rpm reading?

to hook up the tach use the hot lead on the disributor and to any good ground wire and if there is a light hook it to the wire on you light switch


How do you hook up a tach to a 1984 Chevy 350 engine?

if it is a hei ignition there is a place on the distributor cap that says tach.


How to connect the tach to the coil on a 87 El Camino?

Since the coil is in the distributor, simply hook the tach 'trigger' wire to the out put on the side of the distributor cap marked 'tach'.


How do you hook up a tach to a small block Chevy with HEI distributor?

On the dist., cap, where the wires go in, there is a tab labeled TACH.


Where do you hook up the tach wire on the coil of your 92 thunderbid 302 engein?

Hook it to the negative side of the coil.


Why does your tach work but not your speedometer on a 92 Jeep Wrangler?

Tach is driven by a motor signal, speedo is from the trans the sensor is bad on the transmission


What color is the trigger wire on a 1989 Jeep Sahara tachometer?

On the 88 jeep the trigger wire at the tach is blue.


How many rpms does a 1987 suzuki samurai have?

try a tach


Where to hook up the wires for a tach on a 1985 Chevrolet s10 blazer?

You should hook up the wires for a tach on a 1985 Chevrolet s10 blazer to the negative side of the coil. You should be sure to identify the positive and negative sides of the coil.Ê


Which wire do you hook up an aftermarket tach to get a tach signal on a 94 gmc sonoma 2.2 liter?

green wire on aftermarket tachs are the signal wire i belive