You will have to buy a strobe controller.
This is the devices that sends pulsed signal based on the speed/pattern strobe you want.
to install the strobe itself, normally you have to drill into the stock light using the appropriate bit.
Sometimes the paddles get stuck in the baked bread. The wire hook is the best way to get the paddles out.
to hook up the tach use the hot lead on the disributor and to any good ground wire and if there is a light hook it to the wire on you light switch
No. Hook up the power wire first, then the ground wire. The ground wire is what acutually draws the power to the unit. As you will notice the power wont turn on if just the power wire is plugged in..
the purple wire
Cut off the eye of the hook with some wire cutters and then pull the hook through.
Hook up the red wire to the fuse box or another wire that gives power when the key is on. Hook up the white wire to a wire coming out of the headlight switch. This will make is so that when you turn your headlights on, the light will come on on the tach. If you don't mind the light on the tach being on all the time then just hook it to another power wire. Hook the black wire to a ground like a screw or a bolt. The green wire is the signal wire. Run it through your fire wall. Hook it up to the negative side of the coil. There will be a negative sign on the coil denoting the correct side.
Stick a nail in the lemon, then wrap the wire around it. Hook it to the light bulb. Then hook a wire to the lemon and a battery. That's it.
you hook it up to the white wire that comes out of your O2 sensor
hook it to the other orange it controls ur dash lights
you probably have a 3 phase cable?
When wire up a 220 volt compressor look for the red and black hook ups. But if you have a white wire which is a neutral hook that up also to the ground along with the red and black.
Yes-connect the black wire to the brass terminal and the white wire to the silver terminal.
need to know where to hook coil wire is all i need to know.
Hook it to the negative side of the coil.
Hook positive up first, negative last.
What wire do you need to use to hook up air conditioner ? Does it need to be 10/2 with ground? How do I connect this. Thanks!!
You would hook to the negative side of the coil. Some HEI distributor caps are marked "tach".
positive wire to another positive wire
Connect the ground wire to the metal box.
get the right oxygen sensor
theres a wire that is attached to the hook that keeps your hood down, if you can see that wire good. now let me tell you: i have a 92 civic, what i do is pull that metalic wire to left away from the hook and it releases the hood. My wire is connected to the hook but not to the release button inside the car. so if your wire is still connected at both ends you might have more trouble opening your hood.
that wire is for the radio dimmer. when you turn on your headlights the radio dims so your not blinded at night. Some aftermarket stereos have a place to hook this wire up and some don't.
just hook it up to a wire with power when the key is turned on the same wire that turns on your stereo just change the fuse to your stereo from a 10 amp to a 15 amp