The belt is behind the cover with the kick start on most 50cc remove the kick start cover with hand tools to prevent stripping. the variator is the front pulley with rollers behind it. using an air impact remove the front pulley its the easiest way, remove the front pulley and you will see a shaft, place belt on rear pulley (clutch) and pull tightly toward the front shaft. using a flathead screwdriver lightly pry the belt onto the shaft making sure not to harm the belt. it will take some stretching so it wont be easy at first. then replace pulley, tighten it down, replace cover and your all set to ride!
Remove the CVT cover, be careful with fuel drain line and cables, and make sure you put them back where they were. Take off the 17mm nut from the front variator and slide off the outer pulley. you will be able to remove the belt. Squeeze the rear clutch pulley to make it wider and drop in the belt, hold tension on the belt so that the pully does not go back in again, put the belt onto the front shaft, slide the outer pulley back on exactly as it came off and snug the nut, squeeze the belt to get slack and then tighten the variator nut all the way. Carefully put the CVT cover back in place. DO NOT over-tighten the 8mm bolts; they will strip.
im new in ATV a need to install a battery in a polaris scrambler , i have no idea in how to install, help!!!!
CVT generally refers to a Constant Velocity Transmission. This means that the engine will spin a a more constant speed while a vehicle accelerates. A CVT is similar to a snowmobile clutch system where the gear ratio is changed by two clutches that open and close to change the "gear ratio" of the belt that runs between them. this tecnology has been adapted to some automobiles and it is called CVT.
how do you install a serpentine belt on a 1996 corsica?
remove clutch cover. remove old belt. install new belt.
You install it
how to install a serpentine belt on 1989 f250 diesel 7.3l
You should not have removed the tensioner to install the belt. It has a pivot point that and can be moved in order to release the tension on the belt. Once you install the new belt, leave it off the tensioner until last, pivit it and install the belt oner the tensioner.
how to install a drive belt for a 1995 poniac gran am
diagram to install belt on john deere l120
CVT means continuously variable transmission and CVT fluid is transmission fluid for such a transmission.
Pull back the belt tensioner and slip the belt off. Reverse procedure to install.