Should be located on inner fender Connect + battery terminal to one of the large posts Connect cable from starter to other large post Connect smaller "trigger" wire to either of the small posts
How do you install a turn signal switch in a four door 1993 Honda Accord
On a 1993 Ford Mustang : Open the trunk lid or the hatch Between the rear tail lights you will see an oval shaped rubber plug The inertia switch is behind the rubber plug
you push the red reset button on the inertia switch
You Can Put a 1988 Transmission In a 1993 Mustang Body.
I believe yours has a starter mounted solenoid and not a relay.
Answercheck the solenoid wire at started for power when switch at start position.If no power, check neutral safety switch, or main ignition switch on steering column under dash.NOT the key tumbler assembly it has a rod that goes down column to the ignition switch
Remove the retaining ring at the top of your 1993 Chevrolet K 2500 ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
To change a starter from a 1993 Acura Integra remove the mounting bolts that connect it to the transmission. Then unplug the solenoid from the wire harness. Install the new unit.
Which solenoid? BOB
You can get a new top for your 1993 Mustang at Mustangs Unlimited.
look in the owner's manual, also, the inertia switch may be thrown
Behind Tailight trim panel in the trunk look for hole in trim panel.