0
In past models on the passenger side of the firewall there has been 2 hex headed screws about 1" apart with a plug carrying 2 or 3 wires in it, pull the plug. remove the screws, it there is what looks like a spring or 2 in there you found the heater resistor. Go buy a Haynes Auto Repair manual for your car.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the heater resistor located on 1995 gm Yukon?
under right side of dash near blower motor
1995 Nissan Sentra blower motor resistor installation?
Locate the resistor under the dash attached on the blower motor housing. Disconnect the wire harness connector. Remove the resistor and install a new one.
Where is blower motor resistor for 1995 Ford F150?
it should be next to the blower motor
Where is the 1995 Nissan maxima blower motor resistor is?
The blower motor resistor is mounted next to the motor on the passengers side under the dash..............
Where is the heater motor resistor in a 1995 explorer?
its next to the blower motor
Where is the blower motor and resistor on a 1995 dodge avenger?
Blower motor is under the dash on the passenger side.
Where is the motor blower resistor located in a 1995 Ford Mustang?
The blower motor resistor on a 1995 Ford Mustang is located near the blower motor. It is a plug with various colored wires on the passenger side of the vehicle behind the reservoir for the washer fluid.
Why does a 1995 Chevy Caprice fan run on hi only?
The blower fan resistor has rusted out and the contacts are broken. This is a cheap part (~$15) that takes about 10 minutes to install.
Where is the blower motor resistor 1995 chev blazer?
Under the hood, on the firewall, passenger side, close to the blower motor.
Where is blower motor resistor locatied on 1995 fulltime four wheel drive?
They are generally mounted near the blower motor.
What could be wrong if the AC blower on a 1995 Ford Windstar will not blow air?
fuse, wiring, blower motor, blower motor switch, blower motor resistor
How can you get power to the blower motor in a 1995 Mazda b4000?
Check the fuse. Check the blower speed resistor. Check the blower speed control switch.
