Start by removing the connections for the cruise control and brake lights, then remove the bolt that holds the switch to the brake pedal. Once the brake pedal is loose the switch is held on the brake pushrod by a bushing with nylon retaining washers. Carefully remove one washer and slide the bushing out, the switch can now be removed from the pushrod. Installation is the reverse; line up the hole on the switch with the hole on the pushrod, make sure the tabs for the cruise control and brake lights are facing properly. Reinstall the bushing and replace the other nylon washer, replace the bolt and tighten. Lastly connect the brake lights and cruise control.
The engine computer through the brake light switch.The engine computer through the brake light switch.
How to change the brake switch on a 2004 Jeep grand Cherokee Laredo
either behind or in front of the arm of your brake pedal. Follow the brake pedal up until you find a box, either in front of or behind the brake pedal. You will find that the box has a button on it that is activated by your brake pedal, that is the neutral safety switch.
You most likely tripped the NSS =Neutral Safety Switch. I'm guessing you saw a spark while you were messing with your lights. A mechanic can fix this for you.
The brake light switch is located near the top of the brake pedal. When the pedal is depressed the switch is activated and sends current to the brake lights. To access the switch, the under dash panel needs to be removed.
The engine computer through the brake light switch.The engine computer through the brake light switch.
Possibly for the optional Cruise control.
The cruise control is fed by the engine computer through the brake light switch. It does not have a separate fuse.If the engine runs and the brake lights work, it is not a fuse.
On most vehicle the brake switch is one way to shut the cruise off.
The brake light switch is behind the brake pedal.
There are two. The brake light switch and the cruise control cut off switch. You are probably talking about the cruise control cut off switch. When you depress the brake pedal, the brake lights come on and the cruise control stops. Hope this helps
I had to place a small piece of foam between the brake pedal shaft and the cruise control switch. The brake pedal shaft did not "push in" the cruise control switch far enough to let it work. I have had no more problems.
It is quite easy to install the 1992 Chevy Lumina brake light switch. The brake light switch simply plugs in and out.
The 1993 Jeep grand Cherokee brake light switch simply plugs in and out. The brake light switch is located beneath the dashboard on the drivers side of the engine compartment.
On the brake pedal.
It's near the brake pedal or brake light switch.... It deactivates cruise control
The brake lite switch is right over the brake petal. It faces the driver. If you have Cruise on the truck, that switch is in the same spot. It will have a hose running off it. The brake lite switch only has wires.