Step 1. Buy the Installation Kit and Wiring harness that fits the car. ( These cars have ribbon type harnesses and can seriously mess up your car if done incorrectly)
Step 2. Tap into the positive wire from the cigarette lighter for Acc power to aftermarket units.
Step 3. Pull out bezel (just pry out and gently pull.)
Step 4. Pop clips that hold radio in (4) and Pull. (these cars have a dock and lock system)
Step 5. Most aftermarket headunits are deeper than the space provided, Trim the back of stereo compartment as needed.
Step 6. Use wiring harness to wire setero to factory plug. (connect the previously tapped cig lighter wire to the Acc wire on headunit (usually red).
Step 7. Mount using the Dash Kit by the indtructions provided.
Step 8. replace bezel.
Step 9. Test unit and enjoy.
is it hard to replace a waterpump out of a oldsmobile aurora 95
six quarts
Bottom of the oil pan.
It doesn't have one.
Under the drivers seat. On bottom of s.eat, not floor
there is no 94 aurora 95 was the first year Although the Aurora started selling in Q3 1994, the first model year was 1995.
i need diagrama for serpentine belt for 2000 aurora
I believe for the 3.8 v6 the gap is .60
18 to 18.5 us gallons
to get too the battery and fuse panel on a 2001 olds aurora just lift on the front of the bottom seat and it will pull upand u can pull it out.
The northstar engine were remodified to take regular unleaded.I use thw mid in my 01 aurora.
i am replacing the starter on olds 1995 aurora