answersLogoWhite

0


Best Answer

you have to remove the transmission, the driveline (S) depending if its a 4x4, if so u have to remove the transfer case. the transmission and transfer case should be the last step. your clutch sits right behind your tranny.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you install a clutch on a Toyota pickup 1989?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Does a 1989 Toyota Tacoma have airbags?

well, considering that there is no 1989 Toyota tacoma, i wouldn't think so..if you're talking about a 1989 Toyota pickup, then no


Weight for a 1989 Toyota pick up?

The 1989 Toyota pickup had a curb weight that ranged from 2,565 pounds to 3,765 pounds. The '89 Toyota pickup was selected as Motor Trend's 'Truck of the Year.'


Does a 1989 Toyota pickup have a crankshaft position sensor?

Yes


Estimated cost to replace 1989 Nissan 4wd pickup clutch and radiator?

The estimated cost to replace a clutch and radiator, in a 1989 Nissan pickup truck is $1100. A private mechanic may be able to do the job for less.


How do you change the clutch on a 1989 Toyota MR2 turbo?

Take the trans out, the clutch is inside the trans ^_^


Where is the RPM Signal on a 1989 FWD Toyota pickup?

I give up, where?


1989 Toyota pickup what type of oil does it need?

10w-30


Which fuse is for the wipers on a 1989 Toyota pickup?

The fuse for the wipers on a 1989 Toyota pickup are located under the dash, near the hood release. It is in the main fuse panel which controls most of the vehicle's electronics.


What is the stock gear ratio for 1989 Toyota 4wd pickup?

the stock Toyota gear ratio is 4.11


How do check the oxygen sensor on a 1989 Nissan pickup 4cylinder?

install a new one!!


How do you fix a seized clutch on a 1989 Toyota 4x4 pickup with a 22R engine?

Your truck must have been put up for awhile. This problem is virtually unheard of anymore. Hate to be the one to tell you this, but the only proper way to remedy this is to yank the transmission, have the flywheel turned, and the clutch parts replaced.


How do you adjust the clutch on a 1989 Toyota pick up truck?

there is a joint AT THE BOTTOM OF THE CLUTCH AND A BOLT U TIGHTEN THAT AND U ARE DONE I DID IT TO MY TRUCK