Acura Integra

How do you install a cold air intake in a 1990 Acura Integra?

171819

Top Answer
User Avatar
Wiki User
2005-11-02 05:44:42
2005-11-02 05:44:42

1. Remove stock air intake box and hose. 2. Take off passenger wheel to gain access to fender well, remove lower fender well lining behind bumper. 3. Remove the stock intake resonators behind bumper. 4. Install cold air intake tube by routing the tube into the opening under the original stock air box location; attach supplied bracket to secure intake tube. 5. Attach new air filter to the end of the intake and tighten the hose clamp. 6. Reinstall the plastic fender lining, reinstall wheel. 7. Tighten hose clamps on the coupling of the throttle body. 8. Attach air hose from dashpot to the new intake tube.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The intake manifold on a 1990 Acura Integra connects to the head of the engine. Loosen all of the nuts from the manifold to the head, disconnect the throttle body, vacuum lines, fuel injectors and coolant lines then pull the manifold from the head.

User Avatar

On my 1990 integra, there are like 5-8 bolts underneath and 1 or 2 on the inside of each wheelwell

User Avatar

wiper intermittent relay 1990 acura integra

User Avatar

how do you replace an alternator on a 1990 integra

User Avatar

on the intake manifold you should see a vacuum line coming from it connecting to youe throttle body

User Avatar

Yes that year integra is equiped with ABS

User Avatar

Check your negative cable to the battery.

User Avatar

the fuel filter is located on the left side of the engine compartment between the air intake duct and the firewall

User Avatar

Yes it should. Im 99% sure it will. you might want to double check the part number to see for sure. i have a 1990 Acura integra and i have used many parts from integras from 1990- 1993.

User Avatar

Try behind the grill but in front of the rad

User Avatar

i am pretty sure there are no daytime running lamps on a 90' integra...

User Avatar

No there is not a Chip in 90 Integra. I have a 91 intergra and made copies at Home Depot

User Avatar

nope don't believe so, 98 runs on hydro tranny and 90 runs with cable tranny..

User Avatar

124 mph electronically governed

User Avatar

It controls practically everything. It is the "Brains"

User Avatar

The manual that came with my 1990 Acura Integra GS indicates to use Dexron II. If you change the fluid only it's 3.2 qts. I hope this answers your question.

User Avatar

If timing is bad on a 1990 Acura Integra they car will either run incredibly rough out not at all. To fix the timing be sure to correctly align the distributor to the right factory specified degree.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.