I think that as this is quite possibly the easiest engine to do that you should buy a manual and follow the detailed instructions inside.
Sorry but Your question reveals a lack of basic understanding of the back ground for this task.
To repair the head gasket on a 1987 Ford Bronco, the head and the old gasket must be removed. Purchase a new head gasket and carefully install it according to manufacturer specifications.
A short block. A long block is a complete engine ready to install.
a 5.0 is a v8 engine, so there are 8 intake valves.each cylander has 1 intake and one exhaust valve in the head. to install a valve the head must be removed from the engine block
Three basic reasons The fan does not work The cooling system has an air lock (very common) Cracked head, this engine is notorious for doing this
If they both have the same engine.
The four cylinder Fiero engine has a bad problem with cracking the cylinder head. If the gasket is bad it is likely the head will need an expensive repair. If the car has the V6 engine it is possible to just replace the gasket The real question is how good was the engine before the gasket failed? Should it be rebuilt or was it not burning oil and in good condition before the failure. Did the gasket failure cause any damage to the engine?
what is the correct torque for a Toyota Corolla engine - 4E-FE, 1st generation engine?
Drain the radiator, remove the head, drain the oil, replace the oil filter. Install the new gasket and replace the head. Add the correct amount of oil and coolant to the engine. Start the engine and bleed all air from the system.
You will need to remove the cylinder heads from your Ford F1 50 pickup truck engine. Remove the head gasket and clean the surface. Put the new head gasket on and reverse the process.
go to autozone.com current vehicle upper left. choose car repair info vehicle repair guides engine&engine overhaul cylinder head.
You have a bad or missing ground.
You need a tool called a cylinder leakage tester. You remove the spark plugs and rocker arms, install the tool, and pressurize the cylinders to check for damaged valves.The other options are to install a new timing belt and try to start the engine, or remove the head and visually inspect.You need a tool called a cylinder leakage tester. You remove the spark plugs and rocker arms, install the tool, and pressurize the cylinders to check for damaged valves.The other options are to install a new timing belt and try to start the engine, or remove the head and visually inspect.