Want this question answered?
where is the pcv valve located on zuzuki esteem 2001
top engine close to the egr valve
suzuki has a recall on the esteem for a fuel evap valve on the gas tank. if the valve is damaged by hitting the body of the car, then you'll get an engine light indicating a large evap system leak. the recall covers replacing the valve and putting a pad over it to keep it from happening again.
The head bolt torque for a 1998 Suzuki Esteem with the 1.6L 16 valve engine is: 1st: 25 ft lbs 2nd: 40 ft lbs3rd: 48-51 ft lbs
I would look into a stuck open, or jammed Egr Valve.
This is for a 2000 esteem. Give it a try.Steps to replace your idle control valveYou will want to begin by first gaining access to the idle control valve. In order to dothis you will need to remove the air filter assembly, along with the air mass sensor and the air mass meter boot. Once you remove this whole assembly, you should have easyaccess to the throttle body.Remove the four bolts that secure the throttle body to the intake manifold.Usually on the bottom of the throttle body, on fuel injected cars, there is a idle controlvalve. To remove the old valve, simply unscrew or unbolt it.Bolt on the new valve, and reinstall everything. Make sure you replace your throttlebody gasket at this time
99 Durango doesn't have a Heater Control Valve, It only has a thermostat
If you are talking about the IAC idel air control valve,It is as simple as disconnecting the electrical connector from the IAC valve.removing two mounting screws and remove the valve from the throttle body.Installation is reverse.Be sure to install a new O-ring. Good luck!
install updated vent control solenoid valve and jumper harness.
how do install a blow valve on passa 1.8t 99
0.10mm
The EGR valve on a 1998 Suzuki Sidekick is not repairable. It has no replaceable or user serviceable pieces or parts.