answersLogoWhite

0


Best Answer
Copy

If you are talking about the IAC idel air control valve,It is as simple as disconnecting the electrical connector from the IAC valve.removing two mounting screws and remove the valve from the throttle body.Installation is reverse.Be sure to install a new O-ring. Good luck!

User Avatar

Wiki User

โˆ™ 2007-02-23 02:25:12
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: How would you install an idle control valve on a 1993 Mazda MX6?
Write your answer...
Submit

Related Questions

Install air admittance valve?

I would install an AAV if


Where is the egr valve located on a 1992 Mazda b2600i?

I Called the Mazda dealer today and talked with the Mazda Tech and asked him the location of the EGR valve on the 1992 Mazda b2600i. According to the tech only the California models have an EGR valve, I would think that any state with similar laws about vehicle emmisions would require the egr valve also. My truck is from Montana and it doesn't have an egr valve which explaines why I havent been able to find it.


How would you no idle air control valve bad?

1990 Honda accord ex how would you know if idle air control valve is bad?


What is a P1145 code on a 1996 Mazda Protege?

"Intake Valve Timing Control Position Sensor, RH Bank 2" wouldn't think it would be too much to fix on this car.


Why would there be a ticking from valve area on my 1995 Mazda 626?

?? Lifters not getting enough oil ??


How proportional control would perform in a cruise control system?

HOW WORK TO PROPORTIONAL valve


What would labor cost be to install float valve in toilet?

The labor cost to install a float valve in the toilet will depend on the hourly wage of the plumber. The part should take no longer than a hour to replace.


What would one use a thermostatic radiator valve for?

A thermostatic radiator valve is a valve that is connected to the hot water heating system. It can control the room temperature by regulating the amount of water that goes into the radiator. The valve is able to control this by sensing the temperature of the air.


What valves preffered in the upstream and downstream of a control valve ball valve or globe valve?

That would depend on the application such as high steam pressure and if throttling is needed


Can you change from tub spout diverter to diverter on the control?

NO - you would have to change valve out


How do you change the valve stem seals on a 1997 Mazda 626 2l?

The cylinder head must be removed. If you go to that much trouble, it would be best to resurface the head and do a valve job.


What is an imput and output in control technology?

in control technology an input would be a temperature or something of that nature derived from the process and an output would be a signal to control a control valve or actuator that effects the input signal.


Can you install a supercharger and turbo on a 2009 Mazda rx8 renesis engine?

yes, but it would be a complete waste of money to do both


Why would a 1999 Mazda Protege cut out then start and run fine again like nothing happened?

check pcv valve


How and where would you install a shut-off valve on a wall-mount faucet?

I take it that you are mounting it out side, put the shut off valve in side, with a drain on it,


Does Ford own Mazda?

On November 18 2008 Ford announced that it would be selling a 20% stake in Mazda bringing its stake to 13.4%, and surrendering control of the company.


Where is the idol control valve on the engine?

The idle air control (IAC) valve is located on the throttle body. It is the upper of the two units located there. The lower one is the throttle position sensor (TPS).If I had an idol control valve, that jerk Simon and dummy Ryan would have been out of a job a long time ago.


Can you safely remove old Microsoft updates from your computer?

Yes, if you would like to remove(un-install) a program you go onto the control panel and the go onto install, un-install a program then find the program you would like to un-install then click on it and un-install.


How do you install cruise control into a Ford Focus?

my advise would to be have somne one do it for you as u can mess alot of stuff up and install a virus


Where is the Evaporative emission system pure control valve circuit on a VW Passat?

I have a 2000 VW Passat. I need to locate the Evaporative Emission system pure control valve circuit. Any info would be appreciated


What would cause your manual 1998 Mazda truck to rev everytime you shift or take out of gear?

I have a 1997 Mazda B2300 that was having the same problem. When I went to have the emission done it failed. One of the codes on the print out was a possible issue with the Idle Control Valve. I replaced it and that has solved the issue of the high rev when I shift. Still not passing emission though. Hope this helps.


Which valve is the preferred valve to use as flow control valve at the pump discharge 8 inch size ball valve can be used for the same application?

I would use a butterfly valve to set the flow and a pitot tube to measure it. Nexus Valve makes a good one and it is price competetive as well.


Would an idle air control valve cause a car to idle high?

Yes if it is stuck open.


Why would a 1987 Mazda b2200 pickup smoke all the time and not be the rings?

The valve guides in the cylinder head wear out and oil gets sucked in and burned.


What type of faucet valve should I install to protect my children from getting scalded with hot water?

An anti-scald valve would be desirable to prevent your children from getting scalded while using the faucet.