0
I would install an AAV if
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How to install toilet air admittance valve?
put it on ya stink pipe
Is an air admittance valve required on kitchen sinks?
Kitchen sink needs vented out thru roof, but if not possible, some codes allow an AAV to be installed.
What is an air admittance vent?
An air admittance vent is a mechanical sewer vent which allows air to enter into the sewage system but does not allow exhaust of sewer gases.
What is the easiest way to plumb in an island sink drain knowing that you need a vent?
You can use either a "Chicago Loop" to take care of the vent problem. Details can be seen here: http://en.wikipedia.org/wiki/Chicago_Loop_%28plumbing%29 Or another way is tio install an air admittance valve (available at Home Depot).
How do you replace the egr valve on a 99 Mercury Mystique 4-cylinder?
Remove the vacuum hose from the EGR valve. Pull the valve out of the air cleaner housing. Reverse the process to install the new valve.
What precautions should be taken to avoid air locking in hot water pipes of a solar water heater?
install a air bleed valve at the highest point,
How would you install an idle control valve on a 1993 Mazda MX6?
If you are talking about the IAC idel air control valve,It is as simple as disconnecting the electrical connector from the IAC valve.removing two mounting screws and remove the valve from the throttle body.Installation is reverse.Be sure to install a new O-ring. Good luck!
What is the type of air valve?
if you are asking about the air valve on the tire to add/let out air then it is a schrader valve or an American valve
How do you change the egr valve on a 96' dodge neon?
The EGR valve and electrical transducer should be replaced at the same time as they are matched. Remove EGR transducer from the air inlet duct. Disconnect vacuum supply tube from EGR transducer solenoid. Remove air inlet duct. Remove EGR tube to EGR valve screws. Remove EGR valve mounting screws. Remove EGR valve and transducer. Clean gasket surfaces. Discard old gaskets. If necessary, clean EGR passages. Loosely install EGR valve with new gaskets and finer tighten EGR tube fasteners. Tighten tube fasteners to 95 in lb, tighten EGR valve mounting screws to 200 in lb. Install air inlet duct. Connect vacuum supply tube to solenoid. Attach electrical connector to solenoid. Install EGR transducer onto air inlet duct.
How can you fix worn valve seals without removing the head?
There are tools to do just that. Doing one cylinder at a time, you remove a spark plug and install a quick disconnect air fitting in its place. Connect your shop air compressor line to it and maintain air pressure, 100 psi is good. The air pressure will hold the valve in place during this procedure. Now you will need the proper tool to compress the valve spring and remove the retainers (keys) then the valve spring. Remove the old valve seal and replace with a new one, then reverse procedure to install spring and keys. Your local auto parts store should have the tools you need for sale or rent.
Air shocks has to mouch air how do you remove?
The shocks have a air valve just like a tire valve, just take the cap off the valve and depress the insert in the valve to let air out.
How do you install the idle air control valve on a 96 chevY camaro?
Disconnect the battery cables prior to working on the car. Disconnect the power leads attached to the sensor Remove the 2 screws located on the sides of the valve. Gently remove the valve assembly from the car
