On the passengers side of the trans about even with the front of the door fan shaped switch held on by two bolts.
I suggest taking it apart and cleaning it before you think about replacing.
The switch is nearly $300
To remove, flatten out the retaining washer side under nut, remove large nut, remove smaller ( 14mm ) bolt on the adjustment side. Connector for the wires is top left of engine at the firewall, black connector with about 8 wires, you will need to snip 3 or so zip ties to get it free.
cleaning is easy, 6 screws in back, pull apart, clean out all that old grease, pay special attention to the two contacts on the sweeper arm, they should move in and out easily as they have springs underneath and are the man contacts, apply new di-electric grease and reassemble.
reassemble and align before tightening, easiest way is to put trans selector in R and move switch until reverse lights come on.
where do you install a neutral safety switch on a 1996 saturn
The neutral safety switch is located on the transmission, passengers side.
Begin by removing the wiring from the 2002 Chevy Cavalier neutral safety switch. Remove the neutral safety switch retaining screws. Reverse the process to install your new neutral safety switch.
No
Std. transmission would not have a neutral safety switch - if anything it would have a clutch safety switch located usually at the top of the clutch pedal
Many reasons, but a common one is a faulty neutral safety switch, try starting it in neutral.
No. A Jeep Wrangler does not have an inertia switch.
Should be on the left side of the trans right around the shift lever it will have a connector with 3 pins the one in the center is the neutral switch it is also the backup light switch.
Vakavtchiev and Violin invented the neutral safety switch.
where is the neutral safety switch on gm safari
How do you replace the safety neutral switch on a 1995 Jeep Cherokee 5-speed transmission and Where is the safety neutral switch located?
Where is the neutral safety switch on a 2003 trailblazer?