answersLogoWhite

0


Best Answer
Copy

I just did that. I found instructions on autozone.com. The only thing they dont tell you is you will need to get a serpentine belt tool, which you can rent at auto zone and you get your money back when you return the tool.

User Avatar

Wiki User

โˆ™ 2015-07-15 21:26:56
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: How do you install a serpentine belt for a 1991 Chrysler New Yorker?
Write your answer...
Submit

Related Questions

Where is serpentine belt tensioner located on a 1991 Chrysler new yorker salon?

It is the smaller pulley in the center rear of the belt.


Does a 1991 Chrysler 5th ave new yorker have a chip in the ignition key?

No, a 1991 Chrysler New Yorker does not have chip key.


Is the pulley that the serpentine belt is on connected to the water pump on a 1991 Chrysler new yorker?

On a 3.3l the water pump is driven by the serpentine belt. On a 3.0l the water pump is driven by the timing belt.


Where do you find the reset button on a 1991 Chrysler new yorker?

A 1991 Chrysler does not have a reset switch.


Can you access the fuel pump on a 1991 Chrysler new yorker with out lowering the tank?

No, the tank must be lowered to access the fuel pump on a 1991 Chrysler New Yorker.


How do you find a transmission vacuum modulator for a 1991 Chrysler new yorker?

The transmission in a 1991 Chrysler does not have a vacuum modulator.The transmission in a 1991 Chrysler does not have a vacuum modulator.


Is there a ignition kill switch on a 1991 Chrysler new yorker?

No.


Where is the starter solenoid on a 1991 Chrysler new yorker?

on the starter


Where is the fuel pump located on a 1991 Chrysler new yorker?

It is in the tank.


What type of engine oil for a 1991 Chrysler new yorker?

5w30


Headlights went out on your 1991 Chrysler new yorker what do you do?

change the bulb and fuse


What type of brake fluid for a 1991 Chrysler New Yorker?

DOT 3


Can you put 20 inch rims on a 1991 Chrysler new yorker?

Yes, you can put 20 inch rims on a 1991 Chrysler New Yorker vehicle. These rims can be purchased at locations like Discount Tire as of 2014.


How do you replace a serpentine belt in a 1991 Chevy truck?

How to remove and install the serpentine belt on 1991 Chevy Blazer with AC?


Loosen tension pulley 1991 Chrysler new yorker?

To loosen a tension pulley on a 1991 Chrysler New Yorker, turn the nut in the center of the pulley. This will allow the pulley to slide in the cut-out groove so that the belt will loosen.


Where do you put transmission fluid in a 1991 Chrysler new yorker?

Usually through dipstick tube


What is the maximum speed of Chrysler New Yorker 1991?

178 km/h or 111 mph.


What does check gauges mean 1991 Chrysler new yorker?

to look at the gauges something is terribly wrong!!


How many quarts of oil do you need for an oil change in a 1991 Chrysler New Yorker?

4.5 quarts


Where is the fuse box on a 1991 Chrysler new yorker?

Open the glove box and pop off a cover.


Where is the engine computer on a 1991 Chrysler new yorker?

It is behind the battery.It is behind the battery.


Where is the mass airflow sensor located on a 1991 Chrysler new yorker fifth avenue?

It does not have a mass airflow sensor.


Can the engine computer cause the alternator to not charge on a 1991 Chrysler New Yorker?

Yes, the computer is the voltage regulator.


How do you remove the grill on a 1991 Chrysler new yorker?

It simply pops out. It is held in place by four tension springs.


What kind of transmission fluid goes in a 1991 Chrysler fifth avenue new yorker?

Mopar ATF +4