Serpentine Belts
Chevy Silverado
Chevy 350

How do you install a serpentine belt on a 1988 Chevy Silverado?


Top Answer
User Avatar
Wiki User
2015-07-15 19:02:53
2015-07-15 19:02:53

The diagram should be on the fan shroud. If it isn't, draw one before you take it off. It also is in the owners manual. Otherwise go to a used car lot and find a car with a like engine and draw your own schematic,./

To change the belt (and if you have the original type belt tensioner) you need a small oil filter wrench to loosen the belt tensioner to fit the new belt on. Good luck.


Related Questions

User Avatar

How do you change the ignition control module in a 1988 Chevy Silverado 5.7L

User Avatar

The gross weight of a 1988 Chevy Silverado K2500 with a 5.01 engine is about 2.5 tons. This is equal to about 5,000 pounds.

User Avatar

how do install key ignition switch 1988 Chevy s10

User Avatar

on the roght side below the manifold

Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.