19 mm 6-point socket, standard length not deep socket. goes on upper "nut" of idler tension arm. With 1/2" drive, pull towards front to relieve tension; remove belt from idler. Release tension. Complete removing old serpentine belt. Install new belt in same path, same side 'grooved'. Pull on idler arm (19 mm socket) to allow new belt onto idler arm. Check that belt is lined up with all grooves. Release tension; remove tools; done. from Queen Creek AZ.
need diagram of routing for serpentine belt for 2003 toyota corolla
About 20 minutes
You don't, it has a spring loaded tensioner, If the serpentine belt is loose the tensioner has failed and needs to be replaced
So I can put the belt back on the car there are no diagrams on the to show me how it go's on.
how do you install a serpentine belt on a 1996 corsica?
use a 19mm wrench to loosen the tensioner located on the right side of the engine about half way down. remove the belt and then route the new one and install over tensioner.
how to install a serpentine belt on 1989 f250 diesel 7.3l
The 1998 Camry did not have a serpentine belt. Do you have a 1998 Corolla?
you cant tighten it because it has an automatic belt tensioner. it costs about 100 dollars and can be done at home if your mechanical
It does not have a timing belt. It has a chain that drives the camshaft. OR do you mean the serpentine belt on the outside of the engine that drives the alternator, A/C, water pump?
Tighten it.
I have a diagram based on my own Corolla with single belt, but I have nowhere to post it.