0
How do you install a speedometer cable on 1991 mercury topaz gs?
Wiki User
∙ 8y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where do you look for the problem and how do you fix it if the speedometer on a 1993 Mercury Topaz is not working?
Most likely speedometer cable
Where is the speed sensor located on a 1994 Mercury Topaz 4 clynder?
I assume you have a cable speedometer. If so, just follow the cable on the firewall in the engine compartment to the transmission. When you take the cable out there is a small gear in there. That's it.
Are photos available for a 1993 Mercury Topaz water pump install?
picture on how to replace a water pump for mercury topaz
How do you install an alternator on a 1993 mercury topaz?
Battery + cable goes to one of the large posts Starter cable goes to the other Large post Trigger wire goes to the small post (if there are 2 disregard 2nd)
Why is the Speedometer on 1990 mercury topaz not working?
I have the same problem hope someone tells us what to do Mel
When the speedometer for a 86 Tempo fails is it a fuse or part?
definitly a part...either the odometer unit itself, a speedometer cable or just the gear that's in the transmission under the cable...I say this as I've never seen a digital speedometer on any topaz or tempo from 1990 a before
When was Mercury Topaz created?
Mercury Topaz was created in 1983.
Mercury topaz 93 loses power sometimes while driving could it be battery cable ends?
Clean them and see.
What if the speedometer will not work and the transmission will not shift on a 1993 mercury topaz?
Check the fuses, if fuses are okay, it is probably the VSS (Vehicle Speed Sensor) or wiring to it at fault.
How do you change out a fan relay for a 1993 Mercury topaz?
picture of the fan relay for 1993 mercury topaz
How often do you need to change the timing belt in a 94 mercury topaz?
The 1994 Mercury Topaz has a chain and not a belt.
1984 Mercury topaz has a high idol how do you adjust the idol?
"84 is still the carb. There is a small screw right at the throttle cable on the carb. Adjust that.
