It's pretty easy, actually. Just replaced mine, took about a half hour total. Plenty of room underneath the van to work. You have two main bolts holding the starter in. Pull them both, disconnect the wires from the solendoid. Put the new motor in, making sure the splines mesh up. If fitted correctly, the bolts will go right back in easily. Turn key, you're good to go.
On the back of the motor next to the transmition.
It does not take freon. The 1995 GMC Vandura uses the new R134a.
No, the GMC Vandura is a van. If you have the Starcraft conversion, the van is technically considered a station wagon for insurance purposes (much cheaper).
The ECM on the Vandura 2500 is under the Driver's seat.
My 93' vandura has a 5.7 liter 350cubic inch engine.
the starter GMC Yukon?
its hydraulic with abs
Where is fuel filter
Hi: Have you an elctrical diagram for the cruise control of a Citation GMC 1985 (Vandura). Regards.
Where is the starter localed on a 02 gmc envoy?
Best place is a junkyard, the cost a few dollars and you get to learn how to remove and install without having to worry about making a mess.
Begin by removing the tire and wheel from your 1993 GMC. Remove the brake spring and the brake caliper. The brake shoes will come off. Reverse the process to install your new brake shoes.
There is not one.
The 1989 GMC G-Series Vandura takes 16" replacement windshield wiper blades on both sides front.
I have a '94 Vandura and the capcity is 3.0 lbs R134a refrigerant.
my 1992 vandura 6.2 diesel short bus weighs 10,000 lbs
4.1 liter V6
driver side underhood