It is a lengthy project if you do it correctly. You have to just about take the entire tailgate apart piece by piece. I started by removing the tail gate and putting it on some padded saw horses. From there, you just have to keep removing bolts until you get it broken down. The reason it is so difficult is there is a small tab positioned so that you cannot remove the latch -- you will likely see it early on. It is located right in the latch handle area. I took a short cut at this point. You don't have to but it was "a big time saver."
After looking at the tab for a while and procrastinating about taking the tailgate apart, I had my body man take a cutting wheel and remove the tab. You cannot see this when the latch is in place -- it appears to be a security enhancement, not a requirement for looks or operation of the latch. Anyway, it saved a couple hours of work and works/looks fine.
First you need to remove the trim bezel around the handle on the outside of the tailgate. Then remove the three bolts on the inside of the tailgate,that hold the handle in place. Next remove the latching mechanism rods from the handle,and remove the handle from the tailgate.
How do I take off the handle to put a new one on a chevy colorado 2005
If you look where the handle goes you will see 2 rods. Just squezz them together. Are use a screewdriver to pry them towards each other.
go to autozone,buy a handle remover/install tool.very simple and direct.
You have to take off the plastic surround around the handle for the tail gate then pull the two silver rods toward each other or toward the handle and the gate will come down. Most likely the spring has broken or the lock stop and the kit to replace the whole latch assembly is about $35.00.
I have a 1996 Chevy extended cab cheyenne pickup. i need to know how to install a door handle on the passenger side.
how do you install spring on interior door handle of a 98 chevy pickup
Replace serpentine belt on Chevy avalanche?HOW
what size speakers are in the 2004 Chevy Avalanche
how can i repair a 94 chevy k1500 tailgate latch. cannot open gate
Use your jack handle. Side it through the hole in the body just below the tailgate. Guide the end of the handle into the winch assembly. Crank the handle to winch the tire down.
Yes