answersLogoWhite

0


Best Answer
Copy

You need to be more specific as to what you are referring. I am not sure if you are referring to the ignition switch or module.

User Avatar

Wiki User

โˆ™ 2008-08-19 01:47:51
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: How do you install an ignition in a 1997 Chevrolet Malibu?
Write your answer...
Submit

Related Questions

How much should it cost to have the ignition switch replaced on a 1997 Chevrolet Malibu?

parts and labor will cost around 450.00 dollars


Where is the fuel reset switch for a 1997 Chevrolet Malibu?

there is not a reset switch.


Where can you find the fuel emergency switch on a 1997 Chevrolet Malibu?

There is not a fuel cutoff switch or button on a Chevrolet.


Is there a ignition wire diagram for a 1997 Chevrolet Tahoe?

Yes, there is an ignition diagram for a 1997 Chevrolet Tahoe. This is found in a maintenance manual for this car, bought at local auto part stores.


How do you change the oil pump on a 1997 Chevrolet Malibu?

Remo0ve oil pan for access


What is the hose coming from the firewall that is leaking antifreeze from a 1997 Chevrolet Malibu?

It is a heater hose.


How do you remove the light assembly on a 1997 Chevrolet Malibu?

unsrew the main bolt and pull


1997 Malibu theft light on wont start?

needs a ignition cylinder and has to be reprogramed.


How do you bypass the antitheft system on 1997 Chevrolet Malibu?

You don't, you repair it. Normally a wire on the ignition tumbler breaks. You need to check it. We nor I will give out information as you have asked. It would Not be in the best interest of Wikianswers.


How do you remove inner door panel on 2006 Chevrolet Malibu?

what steps are required to remove the inside door panel on a 1997 Chevy Malibu.


Does a 1997 Chevy Malibu have a timing belt or chain?

On a 1997 Chevrolet Malibu : Both the 2.4 litre four cylinder engine and the 3.1 litre V6 engine have a timing CHAIN


How do you replace Malibu fuel door?

Chevrolet made the Malibu from 1964 to 1983 then from 1997 to present. Maybe you could narrow that question down a bit to the model year your Malibu is.


Where can you find the drain valve for your 1997 Chevrolet Malibu?

It is just below the lower radiator hose.


Where is the coolant temperature sensor on a 1997 Chevrolet Malibu?

It is in the intake manifold close to the thermostat housing.


Where is the fuse for the cigarette lighter in a 1997 Chevy Malibu?

The 1997 Chevrolet Malibu cigarette lighter fuse is located in the fuse box. The cigarette lighter fuse will be in the second column, fourth from the bottom.


What are the safety ratings for the 1997 Chevrolet Malibu?

You will have to go to the National Transportation Safety Board website for that information.


How do you release a fuel filter on a 1997 Chevrolet Malibu?

It requires a special tool that can be purchased at a parts store.


How do you drain the antifreeze from a 1997 Chevrolet Malibu?

There is a drain plug just below the lower radiator hose.


Where are the air conditioning O rings located on a 1997 Chevrolet Malibu?

You have O rings on all of the connections.


Where is Where is the fuel pump relay switch on a Malibu?

The model year would help. Chevrolet has been building the Malibu from 1964 to 1983 and then again from 1997 to present.


How can I locate the code for a chipped 1997 Chevrolet Camaro ignition key?

Go to the dealership and they will do it for you.


Where is the crank position sensor located on a 1997 Chevy Malibu?

The 1997 Chevrolet Malibu crank position sensor is located on the back of the crankshaft. The rear engine cover will need to be removed in order to view the sensor.


Where do you find a engine diagram for a 97 Chevy Malibu 2.4?

Engine diagrams for the 1997 Chevrolet Malibu 2.4 liter can be found on the AutoZone site. There are also written instructions on how to remove the engine and install a new one in the Repair Help section under Vehicle Repair Guides.


Where is the throttle position sensor on a 1997 Chevrolet Malibu?

It is on the side of the throttle plate right across from the accelerator cable.


How do you take out and install a switch ignition?

my granddaughter has a 1997 GEO prism LSI. i need to know how to remove the ignition switch