answersLogoWhite

0

You need aP-trap under every sink. Get a plumber if you don't know what you are doing.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

How do you get to ptrap in toilet?

You usually have to unmount it and get at the bottom.


In an older house if you have the metal pipe for the toilet without a flange in the basement can you split the pipe and add the flange to use it for a sink drain too?

Install a ty fitting on the stack in the basement then run it to the sink. Put it low enough to account for a fall in the pipe, to allow proper drainage. Be sure to install a waste and vent pipe to code for both fixtures.


How do you install exuast pipe in a 1985 camaro pipe from cat to muffler?

on a hoist


How do you repair a broken main drain line in a concrete in-ground pool 9 feet deep?

Check out: www.innovativepipeliners.com. They install a pipe lining kit that lines the entire length of pipe without excavation!


How do you repair a broken main drain line in a concrete in ground pool 9 feet deep?

Check out: www.innovativepipeliners.com. They install a pipe lining kit that lines the entire length of pipe without excavation!


How can I install a shower pipe in the wall?

To install a shower pipe in the wall, you will need to first locate the studs in the wall where you want to install the pipe. Use a stud finder to find the studs and mark their locations. Then, use a drill to create a hole in the wall where you want the pipe to go. Insert the pipe into the hole and secure it in place using pipe fittings and a wrench. Finally, connect the pipe to the water supply and test for leaks before sealing up the wall.


What is the proper way to install a bathroom exhaust fan pipe?

To properly install a bathroom exhaust fan pipe, first determine the best location for the fan and pipe. Next, cut a hole in the ceiling or wall for the pipe to go through. Install the fan and connect the pipe to the fan outlet. Secure the pipe in place and ensure it vents to the outside of the building. Finally, seal any gaps to prevent air leaks.


Can i install a US shower head on an Australian pipe?

No. Australian pipe threads are metric and the US is not.


How can I effectively install pipe fitting shelves in my home?

To effectively install pipe fitting shelves in your home, follow these steps: Measure and mark the placement of the shelves on the wall. Install the pipe fittings securely to the wall using anchors or screws. Attach the shelves to the pipe fittings using pipe clamps or brackets. Ensure the shelves are level and secure before placing items on them.


Can you install a 3-inch pipe in a horizontal concrete slab?

The pipe usually goes under the slab.


Can you install a toilet on an existing shower drain?

You need at least a 3 in. pipe -- shower is 2 in. pipe


How do you install a compression fitting?

To install a compression fitting, first cut the pipe cleanly and squarely. Slide the compression nut and ferrule onto the pipe, then insert the pipe into the fitting. Tighten the nut securely to create a watertight seal.