0
The blowoff valve on the Toyota Supra is fairly simple to install. You will need the following items..
1. Tools
2. Toyota Supra manual and repair guide
Now, read through manual until you find the spot where it says how to "install the blowoff valve".
Next, and this is important. READ that part carefully.
After reading the manual, decide what tools you are going to use. Personally, I have a preference for wrenches, pliers, and ladders.
Use your tools (see list item 1)and begin repairs.
Thanks and good luck.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What is the location of expansion valve for Toyota supra?
for a 86-1/2 to 92 supra, the expansion valve is located in the evaporator case. mike b.
Where is the PCV valve located on a 1985 Toyota supra?
There isn't one
How do you adjust idle speed for Toyota supra?
you can adjust it via the idle control valve.
Where do you install a blowoff valve on a 1998 galant vr4?
At the front of the car by the front left wheel, if you can get under there you should see it, you don't even have to pop the bonnet
What does the heater control valve look like in a 88 Toyota supra turbo?
its right beside the wiper switch
Which side of the VTV valve A or B faces the dashpot on a 1985 Toyota Supra?
http://www.cygnusx1.net/Supra/Library/TSRM/MK2/manual.aspx?S=EC&P=3
Where is the blowoff valve located on a 2001 Audi a4 18t?
The Vehicle does not have a blow off valve. so you will never find it.
Can you put a blowoff valve on an stock 2002 Audi a4 1.8t?
yes you can, just replace the stock diverter valve and throw the bov in there
How do you install variable valve timing solenoid in 2000 Toyota celica?
Duct Tape
Where is the turbo and the blow off valve in a 2006 Audi A4?
A4's have no blowoff valve. VW's and Audi's use a completely different setup.
Location Of Vacuum Solenoid Valve In 89 Toyota Supra?
passenger side firewall. behing black charcoal canister, a foot from the hydraulic hood support.
Where is the bleeder valve on 1987 Toyota supra clutch master cylinder?
It's on the slave cylinder which is mounted on drivers side of the transmission right behind the bell housing.
