0
Unplug the wire harness, snip off the wires at the old sensor, use a 7/8" box end wrench over the old sensor to break it loose (CCW), install new sensor using a 7/8" open end wrench, tighten (CW) as you would a spark plug (no need to over tighten), plug wire harness back together, done.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
How do to install oxygen sensor on 2006 Pontiac torrent?
We are asking how to remove and install a oxygen sensor for a2006 pontiac torrent.
How do I install an oxygen sensor in a Mitsubishi car?
where is an oxygen sensor in 2000 mitsubishi pajero io
Ford Fiesta oxygen sensor replacement?
Remove the vacuum hose from the oxygen sensor. Remove the oxygen sensor retaining screws. Reverse the process to install the new oxygen sensor.
Change oxygen sensor on 95 Oldsmobile cutlass ciera?
Remove the oxygen sensor vacuum to. Remove the oxygen sensor screws. Reverse the process to install the new oxygen sensor.
How to replace oxygen sensor on a 2002 ford explorer xlt?
To replace the oxygen sensor disconnect the oxygen sensor electrical connector. Use an oxygen sensor socket to remove the sensor. spray the sensor with penetration oil if it is difficult to loosen. install in reverse.
Where to install the oxygen sensor on a 2002 Mitsubishi montero?
right in the motor!
How do you replace the oxygen sensor on a 1992 Mercedes 190e 2.6?
unplug the connector, remove the oxygen sensor, it is located under the vehicle at the catalytic converter. install new oxygen sensor, plug in connector. done.
How do you install a oxygen sensor on a 2005 silverado?
Screew it out, and screew the new 1 in.
How do you replace oxygen sensor in 2004 Intrepid 2.7 liter engine?
The 2004 Dodge Intrepid oxygen sensor can be found on the back of the air cleaner housing. Remove the wiring harness. Remove the oxygen sensor retaining screws. Reverse the process to install the new oxygen sensor.
How do check the oxygen sensor on a 1989 Nissan pickup 4cylinder?
install a new one!!
How do you install oxygen sensor for Chevy Metro?
you gotta take the old one out first
Where is all oxygen sensors and how do you install an oxygen sensor on a 1999 Lexus RX 300?
inside the exhaust and by dissasembling and swapping it out
