0
They are not too hard to install if you are strong and not afraid to climb into the trunk. Requires two people to do it. One to hold the trunk up all the way and the other to get in and snap the spring back into place. You place the spring end in position first (hole located by the hinge), then locate the torsion end and pushup and back and snap it in place. The only hitch is if the spring didn't break and the bracket itself did, then you will need a body shop to reweld and repair the mounting bracket. Option #2, get a stick and use it to prop up and hold the trunk open when you are using it. Good Luck
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How do you install 1990 Ford Tempo trunk lid springs?
You don't!
How do you install 2001 impala trunk light?
how do you install trunk light on 2001 impala
How do you replace trunk lid springs on a 1983 Mercedes 380sl?
How do you replace trunk lid springs on a 107 body 1983 mercedes 380sl?
How do you install coil springs on a 1996 Camaro?
How do I install rear coil springs on a 1996 Camaro?
Where can you get replacement trunk lid springs?
Sometimes parts on a car grow old and break. Replacement trunk lid springs can be bought at car part stores. The person may have to have them special ordered if they are an older part.
How do you install suspension springs on a mustang gt?
go to autozone
How do you install shackles on a Chevy Trailblazer?
you dont. it has coil springs.
What tool is used to install valve springs?
A valve spring compressor
How do you install a trunk latch on 2004 buick lesabre?
Hire a mechanic!
How do you install a bike rack to a trunk?
A bike rack is installed to a trunk by placing straps around and over the trunk. They are then attached to both sides of the rack and tightened until secure.
How do you Install CLK 430 Emblem?
the one on the trunk pops out easy with a small flat head screwdriver be careful not to scratch your paint on the trunk..
How do you change the tail light on a chrysler cirrus?
Open the trunk, remove plastic nuts from inside. Pull lens out, reverse to install.Open the trunk, remove plastic nuts from inside. Pull lens out, reverse to install.
