Baking soda can be used to control acidity in swimming pools.
Baking soda controls the Total Alkalinity
Soda ash raises the pH or reduces the acidity.
Baking soda will not soften (remove calcium hardness) from pool water. It will raise total alkalinity.
To keep your swimming pool clean you will need a filters and a water pump. A vacuum would as be a good idea.
you need to purchase baking soda, they sell it at wal mart in 12lbs bags in the pool care section, this will keep your water clear and lower the PH
The pool pump does suck the water from the pool. Then it goes thru the filter and (if you use have the following) thru the heater and chlorinator then back into the pool. So - nothing will keep it from sucking water from the pool - but that's a good thing. Now - if you set the valve to a different setting - then it might actually send the water to a waste line - maybe that's what you meant. If that's the case -then the pool pump will eventually drain your whole pool if you have it set to get the water from the bottom drain (another valve).
The Sodium bicarbonate (glorified baking soda) in the water turns your pool water blue. You should maintain 80 to 120 ppm to keep your pool nice and blue. David James Whatley, Jr. Owner of Sky-Blue Pools in Naples, Florida.
Just follow the instruction scoop up the leaves etc and take a sample of water into the pool shop once in a while to make sure you have the water balance right.
Pump the water out or put a cover over the pool.
You have to treat pool water with pool chemicals and use a pool filter to get and keep the water clear.
Both require the same maintenance.
No
In a swimming pool , baking soda (sodium Bicarboante) is used to help keep alkalinity levels in the right target zone. around 80-120 ppm. The important factor is it goes hand in hand with the calcium hardness (200-400) to achieve balanced water. When these are balanced it acts like a buffer for the ph and easier to maintain good clear water along with the sanitizer being used. Ph in turn can damage a pool if its too high or low and the sanitizers effect is related to the proper ph 7.4-7.6
You can, if the water presently in the pool is 'hard' - but be very careful to keep an eye on the Calcium Hardness of the pool water. If you filled a pool with water from the softener, the water would be hungry for calcium and drag it out of the pool walls, making them feel and look like sandpaper. Calcium hardness should be kept within 200-275ppm. best to use regular water for topup and keep the pool water properly balanced (see your local pool store).