answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you know if the clutch shaft release spring on an 1989 Geo Tracker 4x4 is bad?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

1995 escort clutch?

The 1995 Escort clutch has a single dry plate diaphragm spring type clutch. The clutch plate has a splined hub which allows it to slide along the splines on the input shaft. The clutch and pressure plate are held in contact by spring pressure exerted by the diaphragm spring in the pressure plate. During shifting when the clutch pedal is depressed, which transmits hydraulic pressure from the master cylinder to the release cylinder, pushing on the release lever so the throwout bearing pushes on the diaphragm spring fingers, disengaging the clutch.


How do you remove the trans-axle to change the clutch. release bearing will not release from clutch diaphragm fingers?

you have to remove the clutch arm from the top of the trans because there is a stop on the arm stopping the shaft from spinning to release fork inside from bearing.


What is a clutch shaft?

If you are asking what a clutch shaft is related to the installation of a clutch, it is a plastic alignment shaft that is used to line the clutch disc up with the pilot bearing in the flywheel, so that when you install the transmission the transmission input shaft will slide thru the clutch splines and into the pilot bearing in the flywheel with relative ease. They are a must for any clutch installation!


Why is the transaxle noisy when you release the clutch in 1994 VW Golf?

It will be due to the input shaft bearing in gearbox.


What is the name of the gearbox shaft which is 'splined' to accept the clutch plate?

front transmition shaft Input Shaft


Which are three shatfs in a gearbox?

From the engine, there is the clutch shaft which drives/or connected to the Input shaft, which in turn drives the output shaft.


Where is the crank shaft position sensor on a 1995 Geo Tracker?

in the distributor


What drives the gearbox input shaft?

the input shaft has splines on it which connect to the clutch friction plate.


Can an ac clutch leak freon?

No, the leak is propably the compressor shaft seal which is behind the clutch.


What shaft does the brine clutch fit on?

Almost any shaft but on some you need to tape it on. All shafts fit on a brine clutch and the best shafts are totally preference


Which part does not rotate when the engine is running and the clutch is depressed?

Clutch disc, pressure plate, transmission shaft,


Why does the starter rope on a 5 hp Briggs and Stratton not retract on the engine but works fine off it?

The starter rope does not work maybe because the spring may be weak or the ball- bearings in the starter clutch may be jammed and won't let it turn back. If the ball-bearing arn't jammed it could be that the starter clutch is binding on the casing of the recoil if you hit the end of the shaft it may have spread the shaft so it is binding the recoil clutch .