0
How do you know the catalytic converter is bad on an 1997 oldsmobile 88?
Wiki User
∙ 12y ago
Hard starting, loss of power, poor fuel mileage.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you know if a converter is bad on a Kia Rio?
Transmission torque converter or an exhuast catalytic converter?
How do you know when your catalytic converter pieces damage your cylinders?
It can't the converter is in the exhaust system
How do you know if your catalytic converter is bad on your 1997 ford expedition?
Loss of power, hard starting, poor fuel mileage, and a blowing noise under full throttle. Also the converter will get red hot.
How much rhodium in a catalytic converter?
I'm not sure about rhodium, but i know that catalytic converters with platinum contain about 3-7 grams of platinum per converter.
How do you change the catalytic converter on a 1997 ford Crown Victoria?
This work involves a torch and best with air tools. If you are not equipped, then it would be best to take it to a garage. I know, $$$$$$$$
What is the catalactic converter for in a 2000 Subaru Outback?
A Catalytic Converter reduces unburned exhaust gasses.
How do you know when catalytic converter is not working properly?
Loss of power, excess use of fuel, and converter will get red hot.
How do you know catalytic converter is bad?
A bad catalytic converter will cause a severely restricted exhaust system. You would notice a lack of power and performance from you vehicle and in cases of a completely blocked converter, the engine may not run.
How do you know if your catalytic converter is not working on peugeot 206?
cos it sounds noisy!
How would you know if a catalytic converter is required on a vehicle?
If it was built with one, it is required.
How do you know which oxygen sensor on your 95 Dodge Intrepid is bad if the shop wouldn't say which one was bad unless the work is done at their store?
I believe bank 1 sensor 1 is Passenger side before catalytic converter. sensor 2 is after catalytic converter. bank 2 sensor 1 is Driver side before catalytic converter. sensor 2 is after catalytic converter.
My 95 ford explorer is a nice truck but when I go upto 3roms my engine or whatever starts to rattle and I dont know what it is is that something I should be concerned about?
Maybe the heat shield on catalyytic converter Maybe the heat shield on catalytic converter Maybe the heat shield on catalytic converter Maybe the heat shield on catalytic converter
