if it flashes 3 times and then stops then flashes 2 more times that's code 32 and that means you need a clock spring for you steering wheel
Turn on car but do not start wait until airbag light gos out, turn off car before it starts to flash. do this 4 times
Turn on car but do not start wait until airbag light gos out, turn off car before it starts to flash. do this 4 times
To reset your airbag light, in a Nissan Altima, you should turn the car on. From there, as soon as the airbag light stops flashing, turn the car off instantly. Repeat this three times to reset the airbag light.
Once
Cycle the key on and off 3 times, at the third time, leave it in the on position. You should see the 'check engine' light start flashing. It will flash a code at you and you count the flashes to indicate the code number. For instance: a code 43 will flash four times then a pause, then it will flash three times. It will repeat any active codes three times in a row, followed by the next code. Once you get the code '55' you are at the end of the list.
well really alot of ways. for instance if you flash a light three times, it would be considered sos. anything in three that is used for help is usually sos. one time this girl got put into the trunk of a car. and she knew how to use her pocket knife to cut the tale light wires in the car. and she put the wires together three times, making the light blink three times and she was saved by a cop cause of the lights. so you could whistle three times, flash a light three times, alot of stuff
The actor who played Abraham Lincoln in the 2012 film Lincoln was Daniel Day-Lewis. He was born on April 29, 1957 and has won best actor three different times.
Abraham Lincoln joined and rejoined the Illinois militia three times. He served a total of 85 days. During his tenure in the militia he saw no combat duty.
He shoots at Chris Oleson with a Pistol he misses three times before hitting him in the leg
The airbag light in the 2003 GMC ENVOY can be reset by disconnecting the battery for about 5 minutes. Then reconnect the battery, turn the key to on without starting the vehicle, and pump the gas pedal three times if the light is still on after reconnecting the battery.
Turn the ignition set to on without starting the engine. Press the gas pedal three times in quick succession and watch for battery light to flash three times, when it does, it is reset.
Locate the DLC Diagnostic Link Connecter(That where you plug in the scanner) and use a U shaped piect of a paper clip and connect the A and B terminals That's the two on the upper rightCount the # the check engine light flashedItll flash once then twice That's Code 12 meaning good communication from the computerItll flash Code 12 three times then go to the next code flash it 3 times and when done with all codes itll flash code 12 three more times