answersLogoWhite

0

buy a kit off the internet

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Gas tank size in a 1985 bronco ii?

23 gallon all Bronco II's are


How many fuel filters does a 1985 ford bronco II have?

One


How do you replace the thermostat located on a 1985 Ford Bronco II what side of the thermostat go?

how to replace a thermostat on a bronco 198511


Will a 1988 bronco II engine fit in to a 1985 bronco II?

Yes, a 1988 Bronco II engine can fit into a 1985 Bronco II, as both vehicles share a similar platform and engine mounting points. However, you may need to consider differences in wiring, fuel systems, and accessory configurations between the two model years. It's essential to check compatibility for specific engine options and ensure that any necessary modifications are made for a successful installation.


How many teeth have 1985 ford bronco II flywheel?

The flywheel for a 1985 Ford Bronco II typically has 153 teeth. This is common for many Ford small-block engines of that era, which the Bronco II would likely be equipped with. Always check specific vehicle specifications or service manuals for confirmation, as variations may exist based on the engine type or model modifications.


What is the best height for a 1987 ford bronco 2?

== == factory ride height is all you should have in a Bronco II, they are top heavy! Answer: The height depends on what size tires you want to run. I'm running 31x1050x15s on my '84 Bronco ll. I am planning a 3" body lift. To run bigger tires you will need a body or suspension lift. As long as you don't do any radical manuvers ( backing up at high speeds while turning) you shouldn't have any problems. This site has alot of info on lifting your Bll. http://www.therangerstation.com/


Is a bronco 1 or 2 bigger?

There is the FULL SIZE BRONCO and then the Bronco II ( the Bronco II is smaller , eventually replaced by the Ford Explorer)


What is the firing order for a 1985 Ford Bronco II 6 cylinder?

1-4-2-5-3-6


Where is fuel filter on 1985 Ford Bronco II?

2.8L: It is where the fuel line goes into the carb. 2.9L: It is on the driver's side frame rail.


What is the turning radius of a 1988 bronco ii?

The turning radius of a 1988 Ford Bronco II is approximately 34.5 feet. This measurement indicates the minimum space needed for the vehicle to make a complete U-turn. The turning radius can vary slightly based on factors like tire size and suspension modifications.


Will a 1985 mustang rear end fit in a 1985 Bronco II?

Yes, a 1985 Mustang rear end can generally fit in a 1985 Bronco II, as both vehicles share similar chassis and drivetrain components. However, modifications may be required for proper axle alignment and mounting. It's important to consider differences in width, gear ratios, and brake setups, so careful measurements and adjustments may be necessary to ensure compatibility.


How do you adjust the clutch on a 1985 bronco II?

there is really no adjustment that can be made, because it is a hydraulic system, the only thing that can be done is to have a new clutch installed.