0
How do you light a lightbolb with a piece of wire and a battery?
Wiki User
∙ 11y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you make a lightbolb light using battery and wires?
you put the end of the wire at the bottom of the battery and you get the other end of the wire and rap it with the lightbolb and you put the lightbolb at the top of the battery
What material will let electricity to flow between a battery and a lightbolb?
Almost any kind of wire, copper wire being most used.
How do you build a conductivity tester?
Take two pieces of wire, one battery and one light bulb. Battery and light bulb should be the same voltage. Attach one end of one piece of wire to one pole of the battery (Soldering it would be best). Attach one end of the other piece of wire to the other pole of the battery and the other end of the wire to side conductor of the light bulb. You are done. To test the conductivity of something you simply touch the center conductor of the light bulb to one end of what you're testing and the other end of the first piece of wire to the other end of what you're testing. If what you're testing conducts electricity the current will run from the battery through what you're testing into the light bulb, out the other side of the light bulb and back to the battery and the light bulb will light up. If what you're testing doesn't conduct electricity, the electricity from the battery will not be able to pass through it to the light bulb and it won't light up. Good luck!
How do you make a light come on with a battery?
Have a light with two wires going from it. Attatch either wire to the sides (+,-) of the battery, with the wire's other end going into a lightbulb.
Will two batteries and a wire make a light bulb light?
first of all, you need a bulb, a wire, and ONE light bulb. You clip the wire on the battery and touch the wire on the bottom of the light bulb
What do you need to have a simple circuit?
Take a battery, a wire and a little light bulb. Put the wire on the flat part of the battery then put the other end of the wire on the side part of the bottom of the light bulb. Put the end of the light bulb on the top of the battery, dont touch the wire to the top when the light bulb is on it because is either shocks you or doesnt work.
How do you hook up timing light on a 350 Chevrolet and how can you test your light to know its good?
INSERT PLUG WIRE IN SERIES WITH NO. 1 CYLINDER AND CONNECT BATTERY + TO RED WIRE AND BLACK WIRE TO BATTERY - TERMINAL
What are the basic parts of a circuit?
Switch Light Wire battery
How do you make light with a battery?
you have to have 2 wires. then you put a wire to the positive side of the battery(+) and the other wire to the negative side of the battery(-). then both other ends to the light bulb one end to the side and one end to the bottom. you have to have 2 wires. then you put a wire to the positive side of the battery(+) and the other wire to the negative side of the battery(-). then both other ends to the light bulb one end to the side and one end to the bottom.
How do you install utility light on tractor?
You will come off the battery + side with a wire to a fuse, from the fuse to a switch, switch to the light, the other wire from the light goes to ground. Protect the wire from the battery all the way to the light for wear. If you have trouble, or need more info let me know.
What particle does the battery help supply to the wire which helps light the light bulb?
Electrons.
How do you make a circuit with a light bulb and battery?
Get your bulb, it should be a very small wattage (weak) one, get your battery and wires, connect one wire to plus side of abttery and other wire to minus side of battery, then connect to the bulb, you may have to play around a bit to find a connection that produces light.
