If you have the same tv that I do, the 'Setup' button indeed does not adjust the brightness. Use the 'Video' button right next to it on the tv.
Look for the menu button on the manual control pushbuttons.
An electrical switch operated by pressing a button or an operating button.
On my Sharp Linytron TV, there is Setup button on the front of the TV, click it. It will display a menu and one of the options is Air/Cable or Antennae/Cable. Click the Setup button until that menu option is selected. Click the down volume button to select it and enter the Air/Cable options. Click the up volume button to move the selection to Cable. Click the Setup button to accept the selection then again to move to the Exit option. Click the down volume button.
First press the 'set' button.. hold it and press the 'mode' button... Holding this two button press the 'adjust' button.. That is you will be pressing the 3 button at a time. The 'second' will start blinking. Change it by the 'adjust' button. Swap between 'minute' 'hour' 'date' 'month' by pressing mode button simultaneously. Exit by pressing set button
Pressing.
by pressing the X button or the ESC button.
by pressing the off button... then on button
One can tell if a push button switch is on or off depending on the height of the button. If the button gets lower by pressing it, it is turned on (it was initially off). If the button gets higher by pressing it, it is turned off (it was initially on).
http://downloads.devicemanuals.com/dl/rca/RCR311B.pdf
my car has an overhead button that has r))) -its a toggle button so you turn it on and off by pressing it my car has an overhead button that has r))) -its a toggle button so you turn it on and off by pressing it
yes
yes