answersLogoWhite

0

I can't seam to get the holes to line up to put the nut & bolt through

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How does a holes come off a 1993 ford ranger slave cylinder?

You drive the cold roll pin out, BUT if planning on replacing slave cyl, replacing the master line and slave as a unit is recommended more often then not there will be a leak when replacing line.


On a Chevy s10 how do you reinstall the two bushings that go on the Allen bolts and sit between the caliper and the rotor cause there's not enough space?

You should note that the bushings fit into the holes in the caliper. So there really is enough room there. Put the bushings in the holes and fit the caliper over the rotor and work it back into place by jiggling it back and forth and down onto it. Then put the two Allen head bolts back in when the bolt holes line up.AnswerRemove caliper? From the rear?


Replacing the fuel line for a 1969 super beetle?

There was no 1969 "super beetle" only the standard. And which line are you replacing the hard line or the flex line?


Is a flashlight beam an example of a line segment?

Yes, a flashlight beam can be considered an example of a line segment, as it is a finite portion of a line that has a starting and ending point.


When two or more eighth notes are directly next to each other they are joined by what?

What exactly do you mean? The line above it? That is called a beam


What is the first line of holes the book?

The first line of "Holes" by Louis Sachar is: "There is no lake at Camp Green Lake."


Is six hours of labor correct for replacing upper and lower control arms spring perch coil spring insulators strut rod bushings end links and frame bushings on a 1968 Mustang?

Frankly, This is the mechanic covering himself.on a vintage car such as this, there are many different variables that can occur. I'll bet he is just taking a few snapped bolts and stuck bushings into account. if it takes him less time, he will probably credit you the labor. but in short, this is what i would give you as an estimate. Roger Brown New Line Performance


In geometry is laser beam a line or a ray?

A ray


What is a line of reflection?

A line of reflection is a reflected line, often off of a mirror. If a flashlight sends a beam of light at a mirror (the light is called the incident beam), the angle at which it hits the mirror will equall the angle at which the reflected beam of light (called the reflected beam), exits the mirror. This is called the Law of Reflection. This is why light is reflected from a mirror at the same angle at which light struck its surface. A line of reflection is a reflected line, often off of a mirror. If a flashlight sends a beam of light at a mirror (the light is called the incident beam), the angle at which it hits the mirror will equall the angle at which the reflected beam of light (called the reflected beam), exits the mirror. This is called the Law of Reflection. This is why light is reflected from a mirror at the same angle at which light struck its surface.


What is a beamline?

A beamline is the line travelled by a particle beam in an accelerator.


A narrow beam of light that travels in a straight line is a?

A laser


How do you repair a leak in the fuel line?

You'll need to reair the fuel line by replacing the fuel line .