First make sure the #1 cylinder is on TDC firing position you can verify this two ways 1 as you turn the engine over by hand (with all sparkplugs removed) put your finger over the spark plug hole and feel the air pushing or if u have valve covers off both intake and exaust valves will be closed. Now with the timing cover off there are two gears one on the camshaft one on the crankshaft.the mark on the cranf should be pointed straight up 12oclock. the camshaft gear mark should be directly across from it at six oclock.after putting things back togethnor when you put the distributor back in make sure that u have it pointing at #1 than static time it. hook up #1 wir to sparkplug ground plub an block and energize the circuit. twist distributer clokwa\ise until plug fires. tighten down bilt an the block. its easy have fun with it
Yes, a 318 will fit a 6 slant engine in a 1970 Dodge Dart. You will need to also have all a bigger radiator, new engine mounts, fuel line, and clutch to name a few.
Yes, a 318 will fit a 6 slant engine in a 1970 Dodge Dart. You will need to also have all a bigger radiator, new engine mounts, fuel line, and clutch to name a few to complete the project.
The timing mark is a line that goes across the harmonic balancer that should line up with the mark on the timing chain cover. It is on the drivers side on the bottom of the timing cover.
The first Dodge dart rolled off the assembly line in 1960
the cam gear slot is set at 6:00 and the crank gear slot is at 12:00.
The slope is the slant of a line
Its called the slant, and most people say the line segment, but i stick to the slant.
no the body lines are different and wouldn't line up.
go to the library and get a chiltons repair manual for your car.
Slant line is a line which is not horizontal or vertical. In drawing they help to form proportional objects.
Slant line is a line which is not horizontal or vertical. In drawing they help to form proportional objects.
Dart Container Line was created in 1969.