You assemble the pillar to the base plate first, then fit the table and it's winding mechanism onto the pillar. Next fit the pulley box to the top of the pillar and finally the motor on the rear of the pulley box.
A pillar drill, can be an industrial drill or a DIY hand drill, standing on a single vertical post (THE PILLAR) and a mechanism to lower the drill to the workpiece to drill a hole.
they drill
The motor on a pillar drill is usually under the back of the belt casing.
chuck
The drill chuck
A pillar drill can cut through almost any material if the speed is correct and the appropriate drill bit is used.
a pulley gearing is the top of a pillar drill and it helps to pull down the chuck.
In The drill press, which is also often referred to as a pedestal drill, a bench drill or even a pillar drill, was invented in 1895 by an engineer from Germany. His name was Wilhelm Emil Fein.
drop either.......... A lump of concrete on it A piano on it Another Pillar drill on it actually forget the piano!!!!!!!!!!!!!!!!!!
A drill machine can mean a hand held electric drill, or a bench drill press or a pillar drill.
A pillar drill is just another term for a floor mounted drill press
Depending on the type of drill BIT, it may drill through almost anything.