I would get a larger bolt. I would get a larger bolt. If I wanted to make a bolt fit into a larger hole, I would use a SMALLER bolt than the hole.
They should fit. If you jave any doubts measure the distance from bolt hole to bolt hole and compare the two. Or measure from bolt hole rto center pin on both springs. If they are the same then they should fit. yes its the same drive train
how do you make the diamond fit the hole on bin weevils
When assembling two parts, if the shaft is larger then the hole, you then get an interference because the shaft won't fit. A clearance fit is an assembly where a part enters a matching hole with a slightly larger diameter for easy joining or easy removal.
It will not fit without an adapter. The 5 in that number refers to the quantity of bolt holes. The 139.7 refers to the distance between adjacent bolt holes in the pattern. In other words the distance between the upper most bolt hole and the lowest bolt hole in the pattern. Obviously, if the distance between the bolt holes is off by 25.7mm, this wheel will not fit. The only option is to purchase a bolt pattern adapter commonly referred to as wheel adapters, to change the bolt pattern of your vehicle.
Dont be a plank of course it can
yes they will they have the same bolt hole pattern
Baby hole largeafication
One way is to use a combination of washers bigger than the hole that the bolt can tighten against. You might have to get a slightly longer bolt, but all you do is take it with you to a hardware store and match it up or get a new nut and bolt that will fit through the headboard. .
measure the diameter of the hole for the speaker/subwoofer and the distance to each bolt hole to asure you get the right subwoofer to fit properly.
bolt pattern are the same center hole may not be
No they will not.They are 1 bolt hole less then 6.
you can make them fit but I doubt if there a bolt in.