answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you make an electric fence using a car ignition coil?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you make electric fence energizer from car coil?

i have a diagram for the car coil fence


How do you make your own electric fence energiser?

You can use a 12volt car coil.


An ignition coil transforms voltage from a battery to create what?

This intriguing subject brought forth an incredible search of the internet. It turns out the ignition coil transforms voltage from a battery in order to create an electric spark in the spark plugs which leads to the ignition of fuel.


Where is the ignition coil on a 96 civic cx hatchback?

The ignition coil is inside the ignition distributor.


Is Nissans coil in the alternator?

Different Kinds of "Coils"It depends on what you mean by "coil." There are several different kinds of coils.IF you mean the "Ignition Coil," then the answer is no, the ignition coil is not inside the alternator.On the other hand, all alternators, generators, electric motors, etc., do have coils of wire inside, but those coils are generally referred to as "windings."


Is an ignition module the same as a ignition coil?

No. The coil provides the spark and the module tells the coil when to spark.


Mitsubishi Eclipse ignition coil?

Suspect a bad coil or failed engine computer.


What electric problem would cause a 2008 Chevy Impala slow to crank?

It could be a weak battery or a bad ignition coil.


Where is the ignition coil located in a 1998 tercel?

The 1998 Toyota ignition coil is located on the firewall, in the engine compartment. The ignition coil can be found on the passenger side of the firewall.


How do you replace a coil on 2003 Chevrolet Express?

REMOVAL PROCEDURE Remove the engine cover. Disconnect the spark plug wires at the ignition coils. Disconnect the ignition coil harness connector. Remove the ignition coil mounting bolts. Remove the ignition coil. INSTALLATION PROCEDURE Install the ignition coil to the bracket. Install the ignition coil mounting bolts. NOTE: Refer to Fastener Notice in Service Precautions. Tighten Tighten the ignition coil mounting bolts to 8 N.m (71 lb in) . Connect the ignition coil harness connector. Connect the spark plug wires at the ignition coils. Install the engine cover.


How do you test ignition coil on your Alero 1999?

1999 Alero how do i test ignition coil pack


Coil in a sentence?

The ignition coil that is suitable for the hall sensor ignition must have a yellow label.