0
How do you make your four wheel hub stop making noise and fix it you have replace the hub assembly and the vacuum switch on the firewall?
Wiki User
∙ 14y ago
take hub assembly off vehicle inspect and fix damage seals, bearing, exc.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the Headlight circuit breaker in a 1984 Caprice?
It is built into the switch and is not serviceable. You will have to replace the switch assembly.
What do you do if the key is stuck in your Acura Vigor switch?
Replace your ignition lock assembly.
How do you repair a sewage ejector float?
Normally you just replace it as it is not cost effective to replace the switch or float assembly
How do you replace master window switch on Honda Accord 03 coupe?
You have to replace the whole assembly, you cannot replce the switch itself. The assembly pops out with a standard screwdriver and is attached to a wiring harness. The assembley sells on ebay for ~$100-$150.00
Where is relay switch for blower motor on 1999 mercury grand marquis?
it is on the firewall and difficult but not impossible to get to and replace.
How do you switch to offline mode in Dark Souls 2?
You can switch to the offline mode in Dark Souls 2 y making use of the firewall.
Hazard push-in switch keeps popping out is it easy to rewire to new switch fitted on dashboard?
No This is not easy. It is easier to replace the signal light switch assembly
How do you remove the Ignition switch assembly on a 1993 Acura Legend?
you have to replace the whole steering column
What to do if starter is grinding flywheel?
Sounds like solenoid is not releasing or ignition switch is not moving from start to run position. If solenoid is located on top of starter remove clean plunger and replace If solenoid is on firewall replace If the starter is not fully engaging the flywheel, you'll need to either replace the starter or the Bendix/solenoid assembly. If the flywheel has been damaged, you'll need to replace that as well.
How do you remove the ignition switch cylinder to replace it on a 1971 Chevy truck with no key?
With no key you will have to drill out the existing tumbler assembly from the switch in order to unscrew the ignition switch bezel.
How do I replace the neutral safety switch on a 1991 Chevy astro van?
On top of the steering column near the firewall under the dash. There will be a metal rod going into the bottom of the switch.
Volvo 940 replace ac fan switch?
use a piece of duct tape and wrap the clutch assembly
