Unplug the baterry, press brake for 20sec, done :)
Trouble code P1507 means: Idle air control (IAC) underspeed error
Check engine is an error. You have to go at a garage to see what is the error code, then correct the problem.
If there is an AutoZone close by you can go there and they will pull the computer codes for free. If not, you'll have to visit a repair shop with the ability to do so; they typically charge for this.
With a scan tool.
The computer doesn't allow to start the engine. Check the error code.
You need to check your engine. The computer has detected a problem with the engine management system and the light is letting you know that is has error codes stored.
If you have an OBD (On Board Diagnostics) scanner, you can read the error code and reset check engine light. Obviously, if the problem is still occurring the light will come back on. Most of the chain autoparts places will read and reset the OBD for you for free. the scanner read #141
check your engine
P0601 Internal Control Module Memory Check Sum ErrorThe engine computer has failed.P0601 Internal Control Module Memory Check Sum ErrorThe engine computer has failed.
Pretty simple connect an obd2 scanner and it will pull the error codes for the check engine light then look up the error code and diagnose and fix your problem
ANY error code in the computer.
Some of hoses will make for sure the check engine light come on. It depends on the house. If you are sure that it was the hose reset the computer and check your assumption. If you have access to an error code reader check the error code, it might simplify your life.
The check engine light error code PO172 means that the system is too rich. The reason why the system is to rich is due to the mass air flow sensor being dirty or faulty.
It means that you have problems with your engine. It can be the oxygen detector or another malfunction. To make the story short you have to visit your mechanic. Or if you have an error code reader youcan check error codes and figure out what to do next.
That means an error code has been set in the ECU memory. You need to have the codes read with a OBDII scanner, then look up the reference codes in a manual in the engine controls section. A good scanner will tell you what the codes are. Mine was a loose O2 connector.
Not directly. I might if it causes a portion of the engine to detect a malfunction, but that would be a correct error report.
Go to www.banzai-racing.com , it will tell you how to get the error codes and what they are.
P0470 is Exhaust back pressure sensor malfunction.
Number 2 cylinder is misfiring.
If you have an error code reader use it and the error code. If you don't have it, some car stores can read error codes for you (Auto Zone does). When you know the error code you decide what to do.
The check engine light on a BMW 525i is reset by pressing the trip reset button until the engine icon appears. The Check and DC buttons are used to navigate between menus and the trip button held to actual reset the selected error.
its system to lean bank 1
Check the car computer for error codes, google them.
There are thousands of reasons. You need to pull out error codes. You can do it at local autozone store.