answersLogoWhite

0

How do you manufacture splines?

User Avatar

Anonymous

13y ago
Updated: 3/11/2020

56mm diameter with 8 splines, what sizes are the spline widths

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What has the author Donald E Amos written?

Donald E Amos has written: 'Quadrature subroutines for splines and B-splines' -- subject(s): Splines


How many splines does a human have?

A human has approximately 20 teeth which can be considered as splines.


How many splines on a Dana 35 axle?

My Dana 35 is in a 98 ZJ with a 5.9. It has 30 splines.


Which type of key is used for mounting shifting gears in gear boxes?

Saddle key


What has the author Florencio I Utreras written?

Florencio I. Utreras has written: 'Two-dimensional splines' -- subject(s): Splines


Do axle splines go bad?

If the nut isn't tight on the end of the axle, the splines on the axle, in the hub or both can wear out.


Techniques of fitting keys and splines?

It is usually one or the other. Keys are simple, the key goes in the slot and the pulley is aligned and pushed on. Splines usually have a smooth section on the end of the shaft to rest the pulley on, make slight contact with the end of the splines and slowly turn the pulley until you feel the splines match.


How do you remove a harmonic balancer from a nineteen seventyeight trans am?

You need to get a balancer puller to get it off, it's on splines and has to be pulled off the splines.


How do you tell if you have 31 spline axle?

Count the splines.


How many spline on a gu6 g80?

answer is 30 splines


How many splines on a Jeep NV3550 output shaft?

23 Splines. See the Novak NV3550 knowledge base. http://www.novak-adapt.com/knowledge/nv3550.htm


Why are splines are better than keys?

Splines are stronger than the shear strength of a key. More than one key would be stronger than one. eD