Want this question answered?
my bonnet is stuck fast how can i open it.
bonnet wont open with leaver how can I get it open?
this is usually caused by the bonnet release cable getting stuck. try pushing and pulling the bonnet release lever inside the car.
Replace it as a whole unit from the dealers (£20-30 I think), there's just four bolts and the release cable to undo. But if your bonnet is stuck down...(I did this yesterday evening), you will need to remove (if your car has one-not all do) the splash plate/guard underneath the engine-8 to 10 screws. Then you'll need to lie on your back looking up behind the radiator and reach up with a long handled screwdriver and flick the black platic knob/catch to the left-hey presto! On my car the bonnet catch looks ok it's just the release cable that's getting stuck and needs replacing. Hope this helps.
throttle plate stuck, accelerator cable binding, vacuum leak, tps malfunctioning.
the bonnet has two catches it will be the one on the right as you look at the car that's stuck its a pain but to release it you have to go up behind the bumper and the grill and release it by hand it is a bit of a fiddle
How difficult is it ro replace the trunk cable in a 1998 camry? The trunk is stuck shut and I was told the cable snapped. Thanks!
cut the cable or disconnect the cable from the calipers
Hi you check in the dashboard the heating cooling switch . Easy to push to the hot and back or no.? If yes can happened the metal cable come out from under the switch or you have to follow the cable and you find where the water heater switch in the engine water system and you disconnect the cable and try to open or close with hand if is work check the cable not broken or stuck. Most of the time the water switch stuck or the cable come out under the switch from the dashboard side or on the waterline side.
Throttle plate stuck Control cable bound? Throttle body assembly?
Depending on weather it has a cable or hyd. clutch it could be your slave cyld. is stuck or is low on oil. It is cable the linkage might be stuck or your cable is broken or out of adjustment.
I released the pin that holds the gear shift cable and removed cable from arm, than very careful tap the arm on transmission towards radiator, this will put it into park so engine will start, then check cable-it may need to be replaced to work properly.