Want this question answered?
With a key or from the inside.
If it is just the plastic handle broken, behind that is the cable that opens the hood. Just grab the cable with a pair of pliers and pull. You can probably just replace the inside handle and not have to run a new cable.
To open the hood on the 2000 Beetle if the hood release lever is broken inside the car, you can remove the glove compartment of the vehicle and find the release cable inside the dashboard. Pull the cable to open the hood. You will then need to replace the hood release lever.?æ
if you can pull out the cable cut off some of the cable were you can see the wire inside and pull the cable to open
Use pliers and pull the cable...
The cable between the latch and the handle may be broken or needs adjustement to shorten the cable so that the latch will fully release.
That depends on a few things. If the cable has broken at the release handle, you can use Vice Grips or pliers to grab the end of the cable and pull. If the hood is stuck down you can have a helper pull up on the hood while you work the release in the car. If the cable has broken at the latch consult a pro for help. If you get a helper to hold the the hood release open on the inside and tap lightly, with the side of your fist, on the front of your hood just above the grill. This will usually work if the cable is not broken.
corrosion, a broken connector or conductor inside the cable.
It depends on where its broke at. Is the cable broken at the mechanical part or is it broken before that?
Hood release cable has connector nuts on both ends of the cable. Loosen the connector nuts. Remove the cable retainers. The cable will come off and can be replaced with a new hood release cable.
It depends which cable is broken. If the main cable is broken under the truck, the brakes should release on their own. If the brakes dont release, the cables are frozen from rust and need to be replaced. If the release cable from the handle to pedal assemdly is broken reach under the dash above the pedal and find the small release arm. Pull the arm toward you [ the rear of vehicle ] and the emergency brake pedal will release.
On my 1988 Cutlass Supreme the cable broke at the release point in the car. I was unable to see anything from the outside so in the passenger compartment I took the release handle apart and used a set up pliers to pull the cable and release the hood. There should be just on bolt holding the release in place, it may be covered by the carpet. If it can't be done from the inside you can also reach up from under the front bumper and find the cable where it attaches to the latch. Just pull the cable and the hood should release.