Your internal rods of your locking system have failed OR the closing/latching assembly has rusted and is frozen in position.
This job is a pain in the A**, and I would recommend bringing it to the dealer or to your local shop, they can do a batter job fixing it than I could explain over the internet.
However, SOMETIMES, if you're super lucky, while you have the key in the door and turning it to unlock it, pound on the door a bit behind the handle and low. This may cause the door to unlock. If you get it open this way, grease EVERYTHING YOU CAN SEE!!! and try to lock/unlock it again with the door open. If problem persists, bring it to the dealer, this is a headache of a task to fix.
In the owners manual it tells. On my 93 lesabre I had to jump two of the connetors on the code reader
how do i program keyless remote for 2000 Buick LeSabre
Go to http:/www.programyourremote.com It is free and worked like a charm for my '99 LeSabre Limited. Which is not too shabby for a 68 year old grandmother!
You can do it but be careful not to break the prongs
Check your owners manual for a directions on programming your remote. You should find a step by step guide on how to program it.
keep your wii remote level and gentaly glide your remote like your sliding papers across a table
YOU WILL HAVE TO USE A GM PROGRAMER TECH 1 OR TECH 2 I DON'T REMEMBER THE YEAR BREAK
No, remote start was not a factory option in 2000.
If the 94 LeSabre trunk does not have a remote release, check the rear sear to see if the back is removable, to gain access to the trunk. If there is no access, then either a locksmith will need to pick the trunk or you will have to drill the trunk.
It could be the remote has a dead battery. If both remotes don't work, seems like the sensing unit in the car has failed. The remote battery is the easier problem to fix.
no. not on chart means no seat
Dead battery. Broken solder joints. Limited to NO contact with remote buttons to circuit board.