0
Run the turbine up to about 75% speed and trip it manually. Reset the trip linkage. Restart the turbine. Adjust the governor up until the overspeed trip mechanism trips the stop valve. Watch the tachometer, the overspeed trip should activate within 10% over the maximum allowable speed of the turbine, if it doesn't trip it manually and repair the trip.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How over speed protection system works in steam turbine?
by means of mechanical or electrical overspeed protection mechanism
Why turbocharger overspeed?
Overspeed is usually the result of too small of a turbine housing/wheel used.
What happened in steam turbine if governor failed in open position?
It could overspeed and wreck itself-but there are emergency stop valves as well as the governor, so it is unlikely.
What is tripping speed?
in a steam turbine, it is the speed at which the turbine should not go above. some time they call it overspeed trip. because the turbine rotor and berings are not design for such high speed and is not capable to handle this huge cenerfugal forces. usually there is two type of trip system: Electronic and Mechanical. some Steam Turbins have both protaction system.
What is turbine overspeed trip?
Typically two balls with springs holding them down, When the turbine spins too fast, the centrifugal force pushes the balls past the resistance of the springs at which point they hit a lever that stops steam/compressed gas flow to the turbine and the turbine shuts down. They are designed to keep the turbine from going so fast that it damages itself or the piece of equipment it is driving.
What is Steam turbine T S I system?
The TSI system is Turbine Supervisory Instrumentation system, consists of multiple instruments, including speed sensors, speed monitors and so on. The system continuously monitors the steam turbines of all important parameters, such as: rotational speed, overspeed protection, eccentricity, shaft vibration, cover vibration, axial displacement, differential expansion, and thermal expansion. The system helps to improve the availability of steam turbine unit.
What turbine trip is designed to occur at 10 percent above normal operation?
Overspeed trip.
Why extraction taken from steam turbine?
Why extractions are taken out from steam turbine.
Why would you not heat the steam coming out of turbine and feedback to turbine?
becouse this steam is use repetdly for the turbine
What are the preventive maintenance of steam turbine?
The preventive maintenance of steam turbine mainly entails frequent servicing of the parts. This will ensure a smooth performance of the steam turbine.
What type of cycle used in steam turbine?
Rankine cycle is used in steam turbine
What is heat rate of steam turbine How to calculate heat rate of steam turbine?
manish
