Rebar and Post Tension cable (PT) are two entirely different items. Rebar is the static steel bars placed in the concrete while the PT are high tensile strength cables that were placed in concrete than stressed under hydraulic jacking to a tension generally around 2500 to 3500 psi. As a result, the situations for repair are different. The exposed rebar can be cleaned and patched through approved methods. However the PT should be looked at by a professional as it is an integral part of the structure and, as mentioned before, is under tensioned stress. If the exposed rebar is in a PT slab, caution should be used and a professional consulted as well, due the rebar being integrated with the PT.
Supended slab are slab not sit on the ground directlySuspended slab is a slab supported by beams.
1. one way slab 2. two way slab 3. flat slab 4. roof slab
A solid slab is a reinforced concrete slab which is supported by beams or walls..
when the length of the slab is more or equal to twice the breadth hence it has to be one way slab.
bent and tied metal rebar for the slab-to-wall connection at all filled cells bent metal straps embedded into the lintel to connect roof to wall
2" based strictly on the slab thickness. However, it may be governed by form spacing, rebar spacing or rebar clearance to the forms.
You still need rebar, unless you are filling a drop in an existing slab that already has steel in it.
There is no way to answer without a design and the square footage.
varies depending on load to be put on slab, local codes, lots of variables. Check with bldg. dept., better yet a structural engineer.
I assume they would be tied using tie-wire to the rest of the rebar cage.
Waist slab is used in case of stairs. The rebars are bent at some angles on which steps are built.
No. There are plenty of complete driveways with no steel. Assuming you are refering to flatwork and not an actual building foundation.
When the slab is loaded and force applied to it, the top of the slab directly under the load will be put in compression. However at the bottom of the slab. the concrete will pull itself in tension. Put the ends of your fingers together than flex your wrist up. You will feel the pressure at the top of your fingertips and you will see a gap open at the bottom. That is what is happening in a slab. Concrete is strong in compression, poor in tension. Rebar, or steel, is the opposite. By combining the two, you develop a product that is superior and complimentary to the strengths and weaknesses of the individual materials.
Rebar and Post Tension cable (PT) are two entirely different items. Rebar is the static steel bars placed in the concrete while the PT are high tensile strength cables that were placed in concrete than stressed under hydraulic jacking to a tension generally around 2500 to 3500 psi. As a result, the situations for repair are different. The exposed rebar can be cleaned and patched through approved methods. However the PT should be looked at by a professional as it is an integral part of the structure and, as mentioned before, is under tensioned stress. If the exposed rebar is in a PT slab, caution should be used and a professional consulted as well, due the rebar being integrated with the PT.
if by flexible you mean bendable the answer is yes, it can be bent at quite sharp radii, but if you cut a quarter of the way in it will snap at that point.
As a guideline, 4 inches thick, but it would depend on what is going to be sitting on top of it. You may need thicker and/or to reinforce it with rebar.