pump can.
naseer002000
Choke not closing when cold, Accelerator pump in carburetor not working-- Float leval to low.
Try cleaning the carburetor if there is a filter replace it.
it could be many problems but it is most likely the carburetor. check the lines for cuts and if that is fine you should open the top and prime it by pouring gas into the carburetor, just a small amount.
There are two fuel lines that come out of the fuel tank - one with a filter at the end and one without. The line without the filter goes to the IN port of the prime bulb and continues from the OUT port to the top of the carburetor. The line with the filter goes from the fuel tank to the bottom of the carburetor.
If vehicle has a carburetor--accelerator pump could be bad--kit availabe for repair/replacement If onlty happens when cold choke is either not adjusted properly or not working
If the vehicle runs fine otherwise, then the needle valve and seat in the carburetor are defective or stuck open. Could be nothing more than debris in the seat. This allows all the fuel in the float bowl to drain out overnight thus requiring you to prime the carburetor. This fuel ends up in you oil pan and can cause some serious damage if not repaired. Remove the carburetor and remove and replace the needle valve and seat. Be sure to clean everything throughly with a good carb cleaner. Also check the float for pin holes and replace if necessary. You may want to totally rebuild the carburetor if you find it is in bad shape. Be sure and change your oil & filter before driving this vehicle as the oil is contaminated with fuel.
The sensor carburetor uses the sensors in its operation while the electric carburetor uses the electric current in its operation.
It is Fuel Injected and does not have a carburetor.It is Fuel Injected and does not have a carburetor.
It doesn't have a carburetor.
It does not have a carburetor.