The sensor carburetor uses the sensors in its operation while the electric carburetor uses the electric current in its operation.
The MAP Sensor on a 1999 Tacoma is located on the top of the manifold. It is held on by a clip on the driver's side of the Electronic Fuel Injector (carburetor).
no efi stands for electronic fuel injection which takes the place of a carburetor
The throttle position sensor on a 1997 Chevy Venture is located next to the air intake hose on the Electronic Fuel Injector (carburetor). Follow the air intake hose from the air filter to the EFI (carburetor) and it will be on the right hand side where the air intake hose connects to the carburetor.
The TPS (Throttle Position Sensor) on a 1992 Prelude is located in the engine compartment behind the motor. Look for a small sensor just to the left of the spark plug bank next to the EFI (Electronic Fuel Injector) or the carburetor module.
There is no carburetor, the engine is electronic fuel injection. This means there is an injector for each cylinder.
That year vehicle has a carburetor and does not use a knock sensor.
Idle air control valve sensor is located around the carburetor .
Looking at the front of the engine, the MAP Sensor on a 2006 Doge Ram 1500 is located is just to the right of the EFI or Electronic Fuel Ignition (what used to be the carburetor). There are two sensors located here plugged into the EFI. The MAP Sensor is the second one in from the front.
Idle air control valve sensor is located around the carburetor .
a carbureator cause there easier to fix
A 2003 Mercury 115 that runs rough at a low rpm might be having a problem with the MAP Sensor or the Oxygen Sensor. The MAP Sensor is going to be the easiest one to replace because it is usually located plugged into the EFI (Electronic Fuel Injector), a fancy would for carburetor.
The problem is not the cleaning but the reassembly. There are very special tools required for that. You really need to call around and find out who does overhaul your type of carburetor.